Consists of CA-UXQ30S and SP-UXQ10S
由 CA-UXQ30S 和 SP-UXQ10S 组成
UX-Q30W
Consists of CA-UXQ30W and SP-UXQ10W
由 CA-UXQ30W 和 SP-UXQ10W 组成
UX-Q30P
Consists of CA-UXQ30P and SP-UXQ10P
由 CA-UXQ30P 和 SP-UXQ10P 组成
UX-Q30B
Consists of CA-UXQ30B and SP-UXQ10B
由 CA-UXQ30B 和 SP-UXQ10B 组成
For turning off the demonstration
display, refer to page 9.
关闭演示显示的有关详情,请参阅第 9
页。
INSTRUCTIONS
使用说明书
LVT1366-003A
[UF]
Introduction
Warnings, Cautions and Others
/
警告,注意及其他须知事项
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
CAUTION — F button!
Disconnect the mains plug to shut the power off
completely (the STANDBY lamp goes off).
The F button in any position does not disconnect the
mains line.
• When the system is on standby, the STANDBY lamp
lights red.
• When the system is turned on, the STANDBY lamp
lights green.
The power can be remote controlled.
CAUTION
• Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to
get out.)
• Do not place any naked flame sources, such as lighted
candles, on the apparatus.
• When discarding batteries, environmental problems
must be considered and local rules or laws governing
the disposal of these batteries must be followed strictly.
• Do not expose this apparatus to rain, moisture, dripping
or splashing and that no objects filled with liquids, such
as vases, shall be placed on the apparatus.
注意
为了减少触电、火灾等危险:
1. 请勿擅自卸下螺丝钉、盖子或机壳。
2. 请勿让本机受雨淋或置于潮湿环境中。
注意- F 开关!
想要完全关闭电源 (让 STANDBY 灯熄灭),须将电源插
头从插座上拔下。
无论 F 键处于何种位置,主电路仍旧没有关闭。
• 当系统处于待机状态时, STANDBY 灯点发红光。
• 当系统处于开启状态时, STANDBY 灯点发绿光。
电源开关可用遥控器进行控制。
注意
• 切勿堵塞通风口或通风孔。
(如果通风口或通风孔被报纸或布等物堵塞,热量将无
法散出。)
• 切勿在本系统上放置明火,如点燃的蜡烛。
• 想要丢弃电池时,务必考虑环保问题以及严格遵守当地
关于处理废旧电池相关的法律规定和条例。
• 切勿让本机受雨淋、受潮湿、落上或溅上水滴,亦勿在
本机上面放置盛满液体的容器,如花瓶。
IMPORTANT FOR LASER PRODUCTS / 镭射产品的重要说明
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no
user serviceable parts inside the unit; leave all
servicing to qualified service personnel.
3. CAUTION: Visible and invisible laser radiation when
open and interlock failed or defeated. Avoid direct
exposure to beam.
4. REPRODUCTION OF LABEL: CAUTION LABEL,
PLACED INSIDE THE UNIT.
To avoid risk of electric shock and fire and to protect from
damage, locate the apparatus as follows:
Top/Front/Back/Sides:No obstructions should be placed in
Bottom:Place on the level surface. Maintain
In addition, maintain the best possible air circulation.
Front view
前视图
15cm
the areas shown by the dimensions
below.
adequate air path for ventilation by
placing on a stand with a height of
10 cm or more.