
SPEAKER SYSTEM
SX-LT55
Thank you for purchasing a JVC speaker.
Before you begin using it, please read the instructions
carefully to be sure you get the best possible performance.
If you have any questions, consult your JVC dealer.
English
INSTRUCTIONS
LVT0991-002A
[U, UP]

한국어
화면의 색상 왜곡을 방지하는 자기장 차폐 처리가
세트와 가까운 곳에 스피커를 설치할 경우에는, 스피커를

Specifications
Type: 3-way 4-speaker bass-reflex type
Magnetically-shielded type
Speaker unit
Woofer: 13.5 cm cone x 1
Mid and low range: 13.5 cm cone x 2
Tweeter: 1.9 cm dome x 1
Power handling Capacity: 150 W
Impedance: 6 Ω
Crossover frequency: 100 Hz, 4 000 Hz
Frequency range: 32 Hz to 80 000 Hz
Sound pressure level: 89.5 dB/W•m
Dimensions (W x H x D): 300 mm x 1 029 mm x 345 mm
(without feet:
180 mm x 1 000 mm x 326 mm )
Mass: 22.0 kg
Design and specifications subject to change without notice.
SX-LT55
SPEAKER SYSTEM
EN, CS, KO
0704NSMMDWHCE© 2004 Victor Company of Japan, Limited

Unpacking the speaker / /
SX-LT55
7 CAUTION / /
This speaker is heavy, so that have two persons unpack to avoid personal injury or accidentally dropping the speaker.
7 Unpacking procedure / /
1
Open the top (with
mark printed) of the carton box.
Front side
2
Take out the inner carton and the cardboards.
• For the attachment of the feet and speaker grille in the
box, refer to page 2 of the Instructions.
3
Turn the package upside down, then pull it upward.
• When turning the package, hold packing pad in order to
prevent the speaker from falling.
Front side
4
Take out the speaker by removing the packing pad
on the both sides.
• Do not push the front side strongly; otherwise, the
speaker unit will be damaged.
Cardboard
EN, CS, KO
Inner carton (contains accessories)
Packing pad
Cardboard
Cardboard
Cardboard
Front side
LV43379-002A
[U, UP]