Consist of CA-FSSD550 and SP-FSSD550
Consist of CA-FSSD770 and SP-FSSD770
Consist of CA-FSSD990 and SP-FSSD990
REMOTE CONTROL
POWER
DIMMER SLEEP
AUTO
DISPLAY FM MODE
PRESET
PROGRAM
REPEATRANDOM
DOOR
CD
AHB PRO
SLIDE
BASS TREBLE CANCEL
UP
SET
DOWN
FADE MUTING
CD
MD/AUX FM / AM
VOLUME
FS-SD550
REMOTE CONTROL
POWER
DIMMER SLEEP
AUTO
DISPLAY FM MODE
PRESET
PROGRAM
REPEATRANDOM
DOOR
CD
AHB PRO
SLIDE
BASS TREBLE CANCEL
UP
SET
DOWN
FADE MUTING
CD
MD/AUX FM / AM
VOLUME
FS-SD770, FS-SD990
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GNT0008-001A
[J]
Warnings, Cautions and Others
CLASS 1
LASER PRODUCT
CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
For U.S.A
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by
one or more of the following measures :
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician
for help.
IMPORTANT FOR LASER PRODUCTS
REPRODUCTION OF LABELS
1. CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE
2. WARNING LABEL, PLACED INSIDE THE UNIT
CLASS 1 LASER PRODUCT
1.
2.
3.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1
2.
CAUTION
■■■■ About the Internal Cooling Fan
Caution — POWER switch!
Disconnect the mains plug to shut the power off completely.
The POWER switch in any position does not disconnect the
mains line. The power can be remote controlled.
Invisible laser radiation when open and interlock
DANGER:
failed or defeated. Avoid direct exposure to beam.
CAUTION:
Do not open the top cover . There are no user serviceable parts inside the unit; leave all servicing to qualitied
service personnel.
Do not remove screws, covers or cabinet.
Do not expose this appliance to rain or moisture.
This unit includes an internal cooling fan, so as to allow for
high-power operation within a small space.
This fan comes on when the sound level is set high, and may
also come on even at low sound levels if the internal temperature rises. To ensure effective f an oper ation, please leav e at
least 15cm clearance between the rear of the unit and the
wall, and at least 1cm clearance on each side of the unit.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
G-1
Introduction
Thank you for purchasing the JVC Compact Component System.
We hope it will be a valued addition to your home, giving you years of enjoyment.
Be sure to read this instruction manual carefully before operating your new stereo system.
In it you will find all the information you need to set up and use the system.
If you have a query that is not answered by the manual, please contact your dealer.
Features
Here are some of the things that make your System both powerful and simple to use.
■ The controls and operations have been redesigned to make them very easy to use, freeing you to
just enjoy the music.
• With JVC’s COMPU PLAY you can turn on the System and automatically start the Radio or
CD Player with a single touch.
■ The System incorporates Active Hyper Bass PRO circuitry to faithfully reproduce low frequency
sounds.
■ A 45-station pr eset capability (30 FM and 15 AM) in addition to auto-seek and manual tuning.
■ CD options th at include repeat, random and program play.
■ Timer functions; Daily Timer and Sleep Timer.
■ You can connect vario us external un its, such as an MD recorder.
■ The system can play CD-R and CD-RW after they have been finalized.
■ You can p lay back your original CD-R or CD-RW recorded in Music CD format. (However t hey may not be playe d back
depending on their characteristics or recording conditions.)
How This Manual Is Organized
• Basic information that is the same for many different functions - e.g. setting the volume - is given in the section
‘Basic Operations’, and not repeated under each function.
• The names of buttons/controls and display messages are written in all capital letters: e.g. FM/AM, “NO DISC”.
• System functions are written with an initial capital letter only: e.g. Normal Play.
Use the table of contents to look up specific information you require.
We have enjoyed making this manual for you, and hope it serves you in enjoying the many features built into your System.
WARNINGS
• DO NOT PUT ANYTHING ON THE TOP COVER. IF THE SYSTEM IS OPERATED WITH SOMETHING
PUT ON THE TOP COVER, IT WILL BE DAMAGED WHEN YOU TRY TO OPEN THE TOP COVER.
• NEVER REMOVE THE TOP COVER FROM THE UNIT. SERIOUS INJURY MAY OCCUR IF THE SYSTEM IS OPERATED WITHOUT THE TOP COVER.
IMPORTANT CAUTIONS
Installation of the System
1
• Select a place which is level, dry and neither too hot nor too cold. (Between 5°C and 35°C or 41°F and 95°F.)
• Leave sufficient distance between the System and a TV.
• Do not use the System in a place subject to vibrations.
Power cord
2
• Do not handle the power cord with wet hands!
• Some power is always consumed as long as the power cord is connected to the wall outlet.
• When unplugging the System from the wall outlet, always pull the plug, not the power cord.
Malfunctions, etc.
3
• There are no user serviceable parts inside. In case of system failure, unplug the power cord and consult your dealer.
• Do not insert any metallic object into the System.
• Do not insert your hand between the Top Cover and the main body when the Top Cover is being closed.
Make sure that you have all of the following items, which are supplied with the System.
Power Cord (1)
AM Loop Antenna (1)
Remote Control (1)
Batteries (2)
FM Wire Antenna (1)
Speaker Cords (2)
If any of these items are missing, contact your dealer immediately.
How To Put Batteries In the Remote Control
Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment.
R6P(SUM-3)/AA(15F)
CAUTION:
• Handle batteries properly.
■ To avoid battery leakage or explosion:
• Remove batteries when the Remote Control will not be used for a long time.
• When you need to replace the batteries, replace both batteries at the same time with new ones.
• Do not use an old battery with a new one.
• Do not use different types of batteries together.
Using the Remote Control
The Remote Control makes it easy to use many of the functions of the System from a distance of up to 7m (23 feet) away.
You need to point the Remote Control at the remote sensor on the System’s front panel.
STANDBY/ONPOWEROPEN/CLOSE
PHONES
Remote sensor
3
Getting Started
Getting Started
Getting StartedGetting Started
CAUTION:
• Make all connections before plugging the System into an AC power outlet.
Connecting the FM Antenna
Rear Panel of the Unit
SUB WOOFER
CD DIGITAL OUT
ANTENNA
AM EXTFM(75
AM LOOP
OUTIN
MD
/
AUX
COAXIAL
)
Using the Supplied Wire Antenna
FM wire antenna (supplied)
Using the Coaxial Type Connector
(Not Supplied)
A 75-ohm antenna with coaxial type connector should be
connected to the FM 75-ohm COAXIAL terminal.
SPEAKERS IMPEDANCE 4 16
R
L
AC IN
• Before attaching a 75 ohm coaxial lead (the kind with a
round wire going to an outdoor antenna), disconnect the
supplied FM Wire Antenna.
If reception is poor, connect the outdoor antenna.
FM outdoor
antenna
(Not supplied)
Coaxial cable
4
Connecting the AM Antenna
ANTENNA
AM EXTFM(75
)
COAXIAL
AM LOOP
Rear Panel of the Unit
Getting Started
Getting Started
Getting StartedGetting Started
SUB WOOFER
CD DIGITAL OUT
ANTENNA
AM EXTFM(75
AM LOOP
OUTIN
MD
/
AUX
COAXIAL
)
SPEAKERS IMPEDANCE 4 16
R
L
AC IN
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the
Turn the loop until you have the best reception.
tabs on the loop into the slot in the base.
CAUTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power
cord.
5
Getting Started
Getting Started
Getting StartedGetting Started
CAUTION:
• Make all connections before plugging the System into an AC power outlet.
Connecting the Speakers
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords between the Speaker terminals of the Unit and the terminals of the Speakers.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
3. Close each of the terminals to securely connect the cords.
Right side (rear view)Left side (rear view)
Marked with a black line
SPEAKERS IMPEDANCE 4 16
RL
• Since both speakers are the same, you can put either one to the right or left side.
CAUTION:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV.
Removing the speaker grilles
The speaker grilles can be moved.
(FS-SD550)(FS-SD770 and FS-SD990)
When removing:
1. Pull the top forwards you with your fingers.
2. Also pull the bottom towords you.
• When removing the speaker grille from the FSSD990’s speaker, be careful not to damage the cabinet.
(FS-SD550)(FS-SD770 and FS-SD990)
When attaching the speaker grille:
Speaker
grille
Speaker
grille
6
Getting Started
Getting Started
Getting StartedGetting Started
Connecting a Subwoofer
Connect a signal cord (not supplied) between the System’s SUBWOOFER terminal and the input terminal of an external subwoofer.
SUB WOOFER
CD DIGITAL OUT
ANTENNA
AM EXT FM(75 11mm Max/
AM LOOP
*
OUTIN
/
AUX
MD
11mm Max.
)
COAXIAL
* Use the plug whose diameter is 11mm or less.
Signal cord (not supplied)
Powered Subwoofer (not supplied)
Connecting External Equipment
Connect signal cords (not supplied) between the System’s MD/AUX -OUT/IN t ermin als and the out put /in put terminals o f t he
external MD recorder, tape deck, etc.
You can then listen to the external source through the System or record the System’s CD player or tuner to the external unit.
Signal cord (not supplied)
11mm Max.
SUB WOOFER
OUTIN
CD DIGITAL OUT
/
AUX
MD
ANTENNA
AM EXTFM(75
COAXIAL
AM LOOP
* Use the plug whose diameter is 11mm or less.
*
Stereo mini-plug
Signal cord (not supplied)
)
11mm Max.
*
Stereo mini-plug
Pin-plug x 2
Pin-plug x 2
MD recorder or tape
deck (not supplied)
Connecting an MD Recorder, etc (Digital Output)
Unplug the cap and connect an optical digital cord (not supplied) between the System’s CD DIGITAL OUT terminal and the
input terminal of the MD recorder, etc.
You can record the digital output signal from the System’s CD Player to the MD recorder, etc.
Cap
CD DIGITAL OUT
11mm Max.
*
Optical digital cord (not supplied)
* Use the plug whose diameter is 11mm or less.
MD recorder, etc. (not supplied)
7
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.