Page 1
Function of DIP-SW.
(2001/01/22:ITO)
DSW-1 (8-bit) on CPU-board.
1: Prevention of pocket welt slipping device. (ON: working, OFF: not working)
N-type standard is ON
2: Setting of automatic interlining feeder device SA-86N.(ON: with, OFF: without)
This device cannot work when [BA]-mode is No.2. (Clamp-foot down mode.)
3: Setting of automatic flap feeder device SA-83N. (ON: with, OFF: without)
APW-195N&196N only.
4: Setting of welt patch feeder device. (ON: with, OFF: without)
APW-195N&196N only.
5: Bobbin thread remaining amount detecting device. (ON: with, OFF: without)
N-type standard is ON.
6: Setting of small-welt sewing device SA-89. (ON: with, OFF: without = standard)
7: No use. Reserve for long-type. (OFF: standard)
8: No use.(OFF: standard)
DSW-2 (4-bit) on CPU-board.
1: No use.
2: No use.
3: Transport speed of clamp-foot. (ON: normal, OFF: high)
4: No use. Reserve for manual clamp operation.(OFF: standard)
DIP-1 (8-bit) on operation-panel. (See Engineer’s Manual)
1: (OFF: standard. ON: max. sewing length 195mm, max. stitch length 4mm.)
2: (OFF: standard. ON: Can change to C-mode.)
3: (ON: standard. OFF: without thread breakage detector.)
If sewing speed is lower than 1400rpm, no work.
4: No use. 5: Stacker 6: Reserve for APW-196N corner knife.
7: Coner knife. 8: Sewing machine.
DIP-2 (8-bit) on operation panel. (See Engineer’s Manual)
1: Position of clamp-foot.
2-4: Setting of stackers.
5-8: Setting of gauge size.
Loading...