RX SERIES
HYBRID AC POWER FILTERS
O W N E R’ S M A N U A L
RX15- DPCTM
RX10- SCS
7320 Ashcroft, Suite 104
Houston, Texas 77081
Phone: 713.772.1404
Fax: 713.772.7360
www.juicegoose.com
TM
RX Series Owners Manual ...
page 1
02-07 R2
Tuesday, February 13, 2007 14:29
The Juice Goose RX Series products are AC power conditioners that protect against AC line surges and line noise.
These devices use an advanced, patented hybrid AC filter
technology which protects against high voltage electric
power surges and disruptive, high frequency line noise on
the hot, neutral and ground power leads.
GENERAL SAFE USE PROCEDURES
> Use indoors only.
> Avoid dropping the unit.
> Only plug the RX product into a three pronged
grounded outlet. This unit is not to be used with any type
of ground “lift” or pin eliminator.
> Do not open the RX product. There are no user
serviceable parts inside. Opening the unit will void your
warranty.
DISCLAIMER
Juice Goose shall under no circumstances be held responsible for any losses, damage, or injury resulting directly
or indirectly from the use of a RX Series device in a
manner contrary with accepted, safe operating methods
or any instructions contained in this document. The user
should determine prior to use whether this product is
adequate, suitable or safe for the application intended.
Since individual applications can be subject to extreme
variation, Juice Goose makes no representation or guarantee as to the suitability of a RX product for any generally described application.
CONNECTION AND OPERATION
1. Turn off and un-plug electronic equipment.
2. Plug the equipment into the RX unit.
3. Plug the RX unit into a grounded wall outlet.
4. Observe the monitoring lights on the RX device. The
GREEN light confirms properly connected equipment is
RX Series Owners Manual ...
page 2
Tuesday, February 13, 2007 14:29
fully protected. The RED light indicates faulty site wiring
which needs to be inspected. This fault relates to the wiring connected to the wall output. Fault conditions that
would be indicated by the RED light include reverse hot
and neutral leads, missing safety ground and voltage in
excess of 165 volts for over 3 seconds.
Important: if the RED light comes on, for protection purposes, the RX unit will not provide power to connected
equipment. Once the fault has been corrected the GREEN
light will come on and power will be applied to connected
equipment.
Do not attempt to repair faulty wiring. Contact a licensed
electrician.
Some RX Series products are equipped with RJ style connectors that can provide protection for telephone/modem
lines or ethernet data network lines.
5. Plug any source telephone/modem cables into the combination RJ11/RJ45 connector marked “LINE”. Plug the device to be protected into the connector marked ”DEVICE”.
6. Use standard CAT5 cable when using the Network protected RJ45 circuit.
RX Series Owners Manual ...
page 3
Tuesday, February 13, 2007 14:29
RX SERIES
SPECIFICATIONS
DIMENSIONS (in)
RX15-DPC 13.5 x 4.5 x 2
RX10-SCS 2.5 x 4 x 2
CURRENT RATING (AMPS)
RX15-DPC 15
RX10-SCS 10
AC POWER RECEPTACLES NEMA 5/15
RX15-DPC 9
RX10-SCS 1
TRANSIENT ENERGY ABSORBTION (JOULES) 1020
MAXIMUM APPLIED SURGE CURRENT (AMPS) 3000
MAXIMUM APPLIED SURGE PULSE VOLTAGE (VOLTS) 6000
SURGE LET THROUGH RATE (VOLTS)
L-N 10
N-G 0.5
COMMON MODE (N - G) LINE NOISE REDUCTION (dB)
100kHz 30
300kHz 77
1 MHz 80
10MHz 80
30MHz 80
NORMAL MODE (L-N) LINE NOISE REDUCTION (dB)
100kHz 21
300kHz 56
1 MHz 60
10MHz 60
30MHz 60
RX Series Owners Manual ...
page 4
Tuesday, February 13, 2007 14:29
Loading...