JuiceGoose PD1B User Manual
OTHER GREAT PRODUCTS
POWER DISTRIBUTION
JG SERIES – Five great models to
choose from. All include basic spike
and line noise protection and rotated
outlets to accommodate walls wart.
Options include slide out lights and a
voltage meter.
RP SERIES – Professional grade 19”
rack mount power distribution products
for more demanding situations. Features a strong “Tour Class”TM chassis,
10 or 11 outlets and multiple stage
spike and EMI filtration. Options include lights and meter.
POWER SEQUENCING
CQ SERIES – AC power remote control
and sequencing made easy and affordable. Select from 8 different components to build small or large sequencing systems. No master controller required.
UPS – BATTERY BACKUP
Juice Goose is a distributor of great
UPS systems manufactured by Liebert,
a respected name in data power systems support. Models include stand-by
and on-line designs in a full range of
prices.
INSTALLATION
INSTRUCTIONS
November 2002
PD1A and PD1B
FOR MORE
INFORMATION
PLEASE
CONTACT
JUICE GOOSE
AT
WHITENTON INDUSTRIES
7320 ASHCROFT
SUITE 104
HOUSTON, TEXAS
77081
PH: 713-772-1404
FX: 713-772-7360
E: info@juicegoose.com
WEB: www.juicegoose.com
GENERAL WIRING DESIGN
The PD1-A and PD1-B products includes multiple, single phase, 20 amp
circuits and therefore multiple “hot”
and “neutral” wire leads. A common
ground connects all outlets and the
chassis, unless otherwise specified at
the time of order. The “hot” leads are
distinguished by the color of the wire
used. The layout of the circuitry is
specified at the time of order. The
designation of the circuits begins
with the outlets nearest the place
where the wire harness exits the
chassis. These outlets are connected
to the black wire lead which is considered “Circuit #1“. Outlets for
each succeeding circuit are attached
to a different color lead in order as
follows:
Red
Yel low
Blue
Orange
Violet
Brown.
All “neutral” leads are white. All
ground leads are green. The exact
configuration of the wiring is determined by the specifications communi cated with the purchase order.
INSTALLATION
The PD-ONE chassis is designed
with three mounting brackets: one
top, one bottom and one midway on
a side. The PD1-B, because of its
lesser length does not have a side
bracket. All three brackets on the
PD1-A should be used to mount the
unit to a stable surface using appro-
priate hardware such as a #10 machine
screw and nut.
The PD1 is not an “all weather” device.
The surface to which the PD1 is mounted
should be stable and protected from moisture and temperature extremes.
CAUTION
This PD-ONE is intended for commercial
use only and is to be installed only by a
qualified electrical technician. Installation
or use in any manner inconsistent with this
documentation or with customary practice
or local wiring code may cause serious
damage or injury. If a malfunction is observed or suspected, disconnect this device from AC power immediately and contact Juice Goose or an electrical technician.
Each circuit in the PD1 is rated at 20
amps. All wiring and components have
maximum current ratings of 20 amps. Do
not exceed this capacity. Do not disconnect, rewire or replace any components.
SPECIFICATION
The internal and external wiring of the
PD1 is 12AWG THHN. The length of
the external wire harness is specified
with the purchase order. The electrical
receptacles are NEMA 5/20R. All
components are UL recognized.
Loading...