Jokab Safety Smile 11RA Instruction Manual

Original instructions

Smile 11RA/-B/-C

Reset button

ABB AB / Jokab Safety Varlabergsvägen 11, SE-434 39 Kungsbacka, Sweden

www.jokabsafety.com

Overview

General description

Smile 11RA/B/C are reset buttons intended for use in a safety circuit. Smile 11RA is a universal model compatible
with standard PLCs using a NO-contact. Smile 11RB is designed for use with Pluto safety PLC, reducing the
number of terminals needed by one. Smile 11RC is designed for Tina Duo.

Special notes

Pay attention to the following special notes in the document:

Danger of severe personal injury!

Warning!

An instruction or procedure which, if not carried out correctly, may result in injury to the technician
or other personnel.

Caution!

Danger of damage to the equipment!
An instruction or procedure which, if not carried out correctly, may damage the equipment.

NB: Notes are used to provide important or explanatory information.

Safety regulations

Warning!

Carefully read through this entire

The devices shall be installed by a trained electrician following the Safety regulations, standards and the Machine
directive.

Failure to comply with instructions, operation that is not in accordance with the use prescribed in these instructions,
improper installation or handling of the device can affect the safety of people and the plant.

For installation and prescribed use of the product, the special notes in the instructions must be carefully observed
and the technical standards relevant to the application must be considered.

In case of failure to comply with the instructions or standards, especially when tampering with and/or modifying the
product, any liability is excluded.

manual before using the device.

Installation and maintenance

Installation precautions

First mount Smile to the surface with two M5 bolts, then attach the M12 connector.

Warning! The complete unsafe area protected by the safety devices must be observable from the position of the

reset button. The safety circuit must never be reset unless it can be confirmed that the unsafe area is unoccupied.

Incorrect installation:

Warning! The reset button must not be mounted where it can be reached from an unsafe position (e.g. by

reaching an arm around a corner or a finger through a mesh).

Maintenance

Caution! In case of breakdown or damage to the product, contact the nearest ABB/Jokab Safety Service Office or

reseller. Do not try to repair the product yourself since it may accidentally cause permanent damage to the product.

2TLC172096M0201, rev. A 2 www.jokabsafety.com

2011-09-19