John Lewis SHELF WITH 8 HOOKS User Manual
Assembly instructions
SHELF WITH 8 HOOKS
USER GUIDE
Step 1 Insert the wall plugs (C).Step 2
Place template (B) on the wall.
Please use a spirit level to
ensure that the template is
straight. Drill the required holes
in the wall using the template
and follow the guidance on
the 'Wall Fixings' section.
B
Hang the hook rack (A) and mark the hole
Step 4
for the metal plate.
Drill the hole as marked.
A
Screw in the screws (D). Step 3
C
D
Insert the wall plug (C). Hang the hook rack
Step 5
(A) and screw the screw (D) through the
metal plate.
D
A
C
A
Care instructions
Wipe clean with a soft cloth.
Maximum load of 8kg.
Warnings!
The fittings pack contains small items which should be kept away from young children.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
Please retain these instructions for future reference
D
Product Code:
57040191
Pre-assembly
preparation
Thank you for purchasing this product. Please read the instructions and check pack
contents carefully before starting assembly of this product. A full checklist of
components is given in this leaflet. If any components are missing please contact
John Lewis and partners customer services.
This product will take 1 person approximately 30 minutes to assemble.
GUIDE TO WALL MOUNTING & FIXINGS
KEY INFORMATION
Warning:
Phillips head screwdriver
and spirit level required
Fittings and parts
checklist
The fitting pack contains small items which could present a choking hazard and should
be KEPT AWAY FROM YOUNG CHILDREN.
Read this leafl et in full before commencing assembly.
No. Picture Name
Hook
Rack
C
Wall
Plug
QtyANo. Picture Name
1
B
3
D
Template 1
Screw 3
Qty
FIXINGS
installer.
Important - When drilling into the walls always check that there are no hidden
wires or pipes etc.
Take care when drilling on glazed tile surfaces in case the drill slips.
You can use one of the following types of wall plug if your walls are made of brick,
breezeblock, concrete, stone or wood.
General Purpose wall plug
Generally aerated blocks should not be used to support
loads, general – purpose wall plugs can be used.
Plasterboard wall plug
For use when attaching light loads on to plasterboard
partitions.
Cavity Fixing wall plug
For use with plasterboard partitions or hollow
wooden doors.
Helpful advice
before you begin
1. We suggest you spend a short time reading through this leafl et and then follow
the simple step by step instructions.
2. Do not discard any of the packaging until you have checked that you have all the
3. Assemble this product on a soft surface.
4.
tightened during initial assembly. Only upon completion of the assembly should all
5.
fully tightened.
Keep out of reach of small children. It contains small parts which might present a
6.
choking hazard.
7. Do not use any other tools other than those recommended to build this product.
Cavity Fixing – Heavy Duty wall plug
such as shelving, wall cabinets and coat racks.
Hammer Fixing wall plug
For use with walls stuck with plasterboard. The hammer
retaining wall.
Shield Anchor wall plug – Heavy loads
For use with heavier loads such as TV and Hi-Fi
speakers and satellite dishes etc.
Loading...