John Lewis Martha Sleigh cotbed Instruction Manual

Martha Sleigh cotbed

Instruction manual

IMPORTANT - RETAIN FOR FUTURE

REFERENCE - PLEASE READ CAREFULLY

1

Thank you for purchasing this Martha Sleigh cot bed. Please read the instructions and warnings
carefully before use to ensure safe and satisfactory operation of this product.

Your child’s safety is your responsibility. If you have a query with this product or require replacement
Parts, please contact your nearest John Lewis department store.

Lay out the Parts on a soft level surface and compare to the Part/Fixings checklist on pages 2 and 3.
Do not discard any packaging until you are sure that you have all the Parts.

Ensure that your child is kept clear during assembly due to small Parts.

Recommended mattress: 70 x 140 cm

This product complies with BS EN 716 - 1: 2008 and BS 8509: 2008

9

Handle screw x 2

6

Cam nut x 1

7

Wood screw x 10

8

Drawer handle x 2

5

Cam pin x 1

D

Base x 1

A

End panel x 2

B

Side panel x 2

C

Drawer trim x 1

3

65 mm bolt x 8

1

Barrel nut x 4

2

45 mm bolt x 8

4

Wooden dowel x 6

Fixings

Parts

2

I

Base x 2

H

Drawer centre x 1

G

Drawer back x 1

F

Drawer side x 2

E

Drawer front x 1

You will need:
1 x 6mm Allen Key (supplied)
Flat-headed screwdriver
Cross-point screwdriver

Parts (continued)

Take one End panel (Part A) and lay it on edge as shown on a soft surface with the drawer runner
nearest the floor.
Attach one Side panel (Part B) using two 45mm bolts (Fixing 2).
Do not fully tighten the bolts at this stage.

Fixing 2

Cot assembly - step 1

Part B

Part A

3