john lewis HARMONY SEMI FLUSH User guide

Caring for your product

We recommend cleaning with a soft, dry cloth. Do not use abrasive cleaning

materials as these will damage the ﬁnish.

Indor use only. Replace bulbs from John Lewis or established brand of the same type and compatibility.

HARMONY SEMI FLUSH

USER GUIDE

Aftercare and Troubleshooting

Speciﬁcation

5 yea rs guarantee

Rec yc li ng

If you experience any unresolvable technical issues with the product, contact your nearest John Lewis & Partners shop or John Lewis & Partner Technical Support on 03301 230106.

Max. power: 5W Max LED Voltage: 24 0V, 50Hz IP rating: 20 Weight: 0.66kg

At John Lewis & Partners we test every light to high quality standards so we are able to offer you a 5 years guarantee.

This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis & Partners do not operate ins tore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the U K. Please take it to your nearest collection facilit y or for further details contact your local council or visit www.recycle-more.co.uk.

John Lewis Partnership 171 Victoria Street London SW1E 5NN johnlewis.com

Made in Spain

Please retain these instructions for future reference.

Introduction

Warnings

Thank you for purchasing this Harmony semi-ﬂush Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.

This product is Class I and must be earthed.

For your safety, this product must be installed in accordance with local Building Regulations.

Product assembl y

Fix the metal bracket to the ceiling, ensuring there

is a joist at the point of ﬁxing to support the weight

of the product. Mark in the ceiling the position of the bracket holes. Drill in these points ensuring any wire of the existing household wiring could be damaged. Insert the wall plugs, place the bracket over them and screw up the bolts.

Par t s list

If in any doubt, or where required by the law, consult a competent person

who is registered with an electrical self-certiﬁcation scheme. Further

information is available online or from your Local Authority.

To prevent electrocution, switch off at the mains supply before installing or

maintaining this ﬁtting. Ensure other persons cannot restore the electricity

supply without your knowledge.

Always use the correct type and rated power bulb. Never exceed the rated power stated.

When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.

The bulb and surrounding parts can become extremely hot during use.

Imag e Quantity

Having identiﬁed the household wiring from your existing light ﬁtting, connect to the connection block

inside. Ensure that :

You have correctly identiﬁed the house wires.

The connections are tight. No loose strands have been left out of the connection block.

Place the canopy over the metal bracket inserting and tightening the screws. provided.

Fit the shade using the shade retention ring.

Fit the bulb type/rated power as indicated on the luminaire. The rated power indicated must not be exceeded. Switch on the electricity supply at the fuse board.