J&M MA-967 Installation Instructions Manual

Stereo Headset

Amplifier With Mike

Return & Radar

Beep Capability

Part #MA-967

Installation

Instructions

© 2007 J&M Corporation. All rights reserved.

driver's

helmet headset

(not included)

fuse

holder

5 amps

ground to frame—black wire

12v switchable—red wire

female

6-pin din

black

2-pin plug

Radar Detector

black

2-pin plugs

radar connection

black wire—

ground

connection

red wire—

power

connection

Optional

J&M Plug-and-Play

Radar Detector

Connection Harness

(Not Included)

Stereo/Nav Unit

Power Cable

(Not Included)

Stereo/Nav Unit Cradle

(Not Included)

3.5mm plug

MA-967

6-pin

brown plug

stereo audio source

MP3, iPod, Sat Radio, etc.

(not included)

Installation

1) Mount the MA-967 amplifier where desired in the left side of your fair­ing or in a convenient location using the provided screws and nuts, dou­ble back tape, and/or tie straps. Take into account the length of the
wires going to all of the components prior to mounting.

2) Using the supplied butt connectors, connect your Stereo/NAV unit
power harness to the red and black wires from the MA-967 amplifier.
Plug the 2.5mm mono and the 3.5mm stereo plugs from the MA-967 to
your music source or Stereo/NAV unit. Connect the brown 6-pin plug
from the harness to the brown 6-pin plug from the MA-967 amplifier.

(See Diagram) Note: The MA-967 amplifier can be used with your per­sonal music device for stereo audio amplification into the drivers hel­met headset. Simply plug the 3.5mm plug from the connection harness
into your music device and not use the 2.5mm mono plug.