J&M JMDM-IPAX-GL18 Installation & Operating Instructions Manual
Digital Music
Player
For 2001-2010
Honda GL-1800
Part #JMDM-IPAX-GL18
Installation
& Operating
Instructions
© 2011 J&M Corporation. All rights reserved. 3/11
Included Parts:
• Digital music player
• SD card (pre-loaded with sample/test MP3 files)
• GL-1800 connection harness
• iPod connection cable
• Auxiliary extension cable
• SD card reader/writer
• Velcro strips for mounting
Note: The DIP switches on the JMDM-IPAX-GL18 are set at the factory to the
ON position and all four switches must be left ON in order for the digital music
player to function correctly.
This exciting new digital music player from
J&M will plug directly into the CD selected
music input plug on all 2001-2010 Honda
Gold Wing audio systems, replacing the
Honda CD changer, at a fraction of the
cost.
Store and play up to 884 MP3 song tracks
from your music library on a single SD card,
(exact # of song track storage and playback
will vary depending on model year of the
GL-1800) and toggle thru song after song
using your existing handlebar audio system
controls.
Plug in your iPod®or iPhone® with your
favorite music files stored, and toggle thru
song after song, or playlist after playlist,
using your existing handlebar audio system
controls, without discharging your iPod’s
internal battery.
Plug in your remote mounted Satellite radio
receiver or MP3 player, using the 3.5mm 3conductor plug accessory cable and enjoy
high-quality stereo music thru the Honda
audio system CD selection.
All of these possible music sources can be
played, while still maintaining all of the
normal integrated functions of the GL-1800
audio system, including driver-passenger
intercom and CB radio.
Control head mounts down into the base
inside the tail trunk, in place of the CD
changer, as a complete plug-n-play
installation.
This digital music player kit includes a
direct plug-n-play harness for the GL-1800
audio system, SD card reader/adapter, USB
cable extension for iPod, 3.5mm aux
extension cable for satellite radio or MP3
player, pre-loaded 4Gb test SD card, pregummed Velcro mounting strips and
complete installation and operation
instructions.
Important Note: When installing this unit
on 2009-2010 GL-1800s, if you wish to
use the XM satellite radio feature of your
audio system, with this digital music
changer, you will need to purchase at
additional cost J&M part# JMDM-ADT-GL18.
A
1
1/4”
Installation
1. Remove seat.
2. Locate the mark on the lower left edge of the tour pack and drill a 1 1/4” hole.
Diagram A
3. Route the included cables through the hole and install the supplied rubber grommet on
the cables and into the 1 1/4” hole.
Black
Rubber Boot
Relay Box
B
Cross Member
14-pin
Connector
4. Locate the white 14 pin plug located in the black rubber boot next to the cross-member
and relay box under the seat. Diagram B
5. Plug the white 14 pin connector from the JMDM-IPAX-GL18 harness into the
corresponding plug on the bike. NOTE: The cable must be routed under the cross member
to prevent damage to the cable.
6. Plug the 20 pin plug on the harness in to the JMDM-IPAX-GL18.
7. If you wish to use the iPod function, route the included iPod cable to your handlebar
mounted iPod, or desired mounting location.
Loading...