JL Audio C5-570x, ZR570-CSi User Manual

SB-GM-SLVEXT2/10W1v2 INSTR_SKU# 011300
I N S T A L L A T I O N G U I D E
for the
SB-GM-SLVEXT2/10W1v2
SKU#94465,94467,94468,94469,94470,94472
2007+
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.
®
be properly mounted to the vehicle according to these
S T E P 1
Empty out the area under the back seat so that you have a Clean area to work in.
S T E P 2
Measure 14” in from the insdie of the rear sill trim as shown, this should be the center of the 3” x 3” Wax Square.
INSTALLATION D I F F I C UL T Y:
OU T OF
25
ESTIMATED TIME: 1 HOUR
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
14”
S T E P 3
Thread the Mounting Stud into the bottom of the Stealthbox® so that only 1/4”- 3/8” is exposed.
Continued on Next Page
S T E P 4
+12VDC Ground Remote Preamp Output Section
Infrasonic Filter
“Q” Center Freq. Boost (dB)
Amp LP Filter
Advanced Bass Control
Amplifier Input Section
Subwoofer Output
MONO OUT PUT O NLY
Left Output Right Output Left Ch. Right Ch.Filter Freq. (Hz) Filter Freq. (Hz)Infrasonic Freq. (Hz) Remote Bass Port
Full Range | Amp Filter | Out Filter
Output Mode Filter Slope Mode
Mode | Slope
Input Voltage Input Sens. Signal Sensing
12dB| 24dB
Filter Mode
LP| HP
Bass EQ
Off | On
Off | 12dB | 24dB Low | High Off | OnOff | On
40
45
556580
100
200 15
18
223045
55
60 40
45
556580
100
200
0.5
0.7
1.1
1.6
2.7
4.3
20
25
304060
75
80 0
+4
+10
+13
+15
500 /1v2
Monoblock Subwoofer Amplifier
Line up the Stealthbox® so that the seat belt anchor bolt is centered in the recess in the enclosure. Press down on the Stealthbox making and imprint in the 3” x 3” wax square with the Mounting Stud. Remove the Stealthox® and drill a 1/2” hole through the floor where the mark was made.
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a
reduction in your weekly pay.
Always wear eye protection when drilling!
S T E P 5
Back the Mounting Stud out of the Stealthbox® so that approximately 1-1/4” is exposed, set the Stealthbox® back into place, with the Mounting Stud going through the freshly drilled hole.
I N C L U D E D H A R D W A R E
SB-GM-SLVEXT2/10W1v2 INSTR_SKU# 011300
1) 3/8-16 x ***” Mounting Stud 1) 3/8 x 1-1/4” Fender Washer
1) 3/8” Split Lock Washer 1) 3/8-16 Hex Nut
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed) Driver Type: (2) 10W1v2-8 Nominal Impedance: 4 ohms Continuous Power Handling: 600 watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends high quality amplifiers such as the JL Audio HD900/5, 500/1v2 or J2 500.1. The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier.
All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more detailed information about installing and tuning your amplifier.
C O N N E C T I O N S
Page 2 • JL Audio, Inc 2009
S T E P 6
Install the included Fender Washer, Split Lock Washer and Hex Nut as shown, tighten them down.
S T E P 7
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XC-PCS4-1B for your Stealthbox® amplifier, other kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio reccommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi
(954) 443-1100
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# ******** **-**-2009 • Printed in USA • ©2008 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
w w w. j l a u d i o . c o m