JET DC-RC230 Operating Instructions and Parts Manual

Dust Collector RF Remote
Power Control

The RF Remote Power Control (Figure 1) should be
used for activating Dust Collection units only (115V
units up to 1-1/2HP, 230V units up to 3HP). Not only
can devices be turned on and off remotely, but if
more than one remote power control unit is used for
other devices, a unique frequency can easily be
assigned to each unit by means of DIP switches
located on the main unit and remote control switch.

Specifications

RF Remote Power Control

Model .................................... DC-RC ............. DC-RC230

Stock No. (Unit) ................. 708636C ................ 708636D

Stock No. (Transmitter) ..... 708636T ................. 708636T

Power .............................. 115V, 1Ph .............. 230V, 1Ph

Remote Control Type .................. RF .......................... RF

Use ................................. Indoor only ............. Indoor only

Net (Gross) Weight ....... 2 (2-1/2) lbs ............ 2 (2-1/2) lbs

Dust Collector Requirements

Voltage Type ................... 115V, 1Ph .............. 230V, 1Ph

Max HP .................................... 1-1/2 ............................. 3

Outlet Rating (min) .................... 20A ......................... 20A

Circuit Breaker (min) .................. 20A ......................... 20A

Before hooking up to the power source, make sure
that the switch is initially in the off position on both
dust collector (or other device) and remote control
unit (Figure 1).

Turning the DC-RC On & Off

This machine is intended for
indoor use only.

To start a machine or device:

1. Turn the machine itself on.

2. On the main unit (Figure 2) place the switch to
the ON position. The red LED on the main unit
should light up.

3. Press the button on the remote control
transmitter (Figure 1).

Figure 1

4. To stop the machine, press the remote control
transmitter again.

When the machine is running, it can be stopped by
placing the switch on the main unit (Figure 2) in the
off position. To restart, repeat steps 2 and 3.

Figure 2

JET

427 New Sanford Road
LaVergne, Tennessee 37086 Part No. M-708636C
Ph.: 800-274-6848 Revision B1 04/14

www.jettools.com Copyright © 2014 JET

Changing Operating Frequency

If several devices are controlled by the same type
remote control unit, each remote control unit can be
set to operate at its own unique operating frequency
as follows:

Referring to Figure 3:

1. Unplug the DC-RC Remote Power Control unit
off.

2. Remove the back covers of the main unit (A) and
remote control switch (B).

3. Locate the DIP switch (C) in each unit.

4. Change the position of the DIP switches in the
main unit (A) to any combination desired as long
as they are not the same as other units that may
be present and located within the radio frequency
range.

5. Set the DIP switches (C) in the remote control

switch (B) to match the switch settings in the
main unit (A).

6. Replace the back covers to the main unit and
remote control switch.

7. Operate a device as described in Turning the
DC-RC On & Off and verify that other devices
using the same type remote control do not turn
on.

Figure 3

Customer Service

To reach our service department, call 800-274-6848 between 7:30 a.m. and 5:30 p.m. (CST), Monday through
Friday. Having the Model Number and Serial Number of your machine available when you call will allow us to serve
you quickly and accurately.