JET CBS-1340 Operating Instructions and Parts Manual

Assembly Instructions

CBS-1340 Lathe Stand

For Jet Lathe Models BDB-1340A and GHB-1340A

CBS-1340 Stand shown with BDB-1340A Belt Drive Lathe

JET

427 New Sanford Road
LaVergne, Tennessee 37086 Part No. M-321443AK
Ph.: 800-274-6848 Rev. B 02/2017
www.jettools.com Copyright © 2017 JET

Contents of Shipping Container

Middle Panel Carton

1 Panel

Right Panel Carton

1 Right Panel
1 Hardware Kit
1 Manual

Left Panel Carton

1 Left Panel

Tools Needed for Assembly:

Cross Point Screw Driver
10mm Open End Wrench
19mm Open End Wrench
26mm Open End Wrench
4mm Hex Wrench

Assembly Instructions

Note: number in “( )” p arenthesis refers to the

index number in t he parts breakdown and par ts
list.

1. Take off Bolt (8), S pacer (17) and Nut (15)
by Door Latch Assembly.

2. Put Ha ndle (11), Bolt (12), and W asher (13)
through hole of door.

3. As semble Nut (15), Latch (16) , Spacer (17),
and Bolt (18) onto back of door.

4. Assemble Center Panel (1) with Left Plinth
(3) and Right Plinth (2) with Screws (8),
Latch (16) and Nut (8).

5. Install lathe onto stand and tighten with Bolts
(4), Washers (5), Lock Washers (6) and
Nuts (7).

2