JET BE-20 Operating Instructions and Parts Manual

BE-20 Bed Extension 20”

Assembly

1. Tap straight end of t aper ed pin ( A ) into the centering hole on the bed extension with a wooden mallet.

2. Lift into position and line up tapered pin that is mounted into the bed extension with the matched
centering hole in lathe bed.

3. Mount the bed extension (B ) to your JET Wood Lat he with four 3/ 8”-16x 1-3/4” hex socket cap screws
(C), four 3/8” loc k washers and four 3/8” flat washers. Snug the screws but do not ti ghten.

4. Move tailstock over the joint, and line the clamping nut in the center where the two beds meet.
Tighten tail stock clamping lever, and tighten the four hex socket c ap screws that connect the beds.

5. The stud that is loc ated at the tailstock end of the lat he bed will need to be m oved t o the f ar end of
the extension bed.

WMH TOOL GROUP

Consumer/Light Industrial Products Division
P.O. BOX 1349
Auburn, WA 98071-1349

▪

Ph: 1-800-274-6848
E-mail: jet@wmhtoolgroup. co m M-708346 10/02
www.wmhtoolgroup.com

Fax: [phone]

Copyright © WMH Tool Group

20” Bed Extension Breakdown

20” Bed Extension Part’s List

Index Part
No. No. Description Size Qty.

1..........JWL1642-401............... 20” Bed Extension ................................. ...............................................1

2..........JWL1642-302............... Tapered Pin........................................... ...............................................1

3..........TS-0680041 ................. Flat Washe r...........................................3/8”.........................................4

4..........TS-0720091 ................. Lock Was h e r ..........................................3/8”.........................................4

5..........TS-0209081 ................. Hex Socke t Ca p Sc re w..........................3/8”-16x1-3/4 ”.........................4