Jensen SMPS-628 User Manual

USER MANUAL
UNDER CABINET UNIVERSAL BLUETOOTH
MUSIC SYSTEM
SMPS-628
PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
COMPLIANCE WITH FCC REGULATIONS
Follow the advice below for safe operations.
ON PLACEMENT
 
E-1
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Should any trouble occur, remove the power source and refer servicing to qualified personnel.
Do not restrict the airflow of the unit by placing it in a place with poor ventilation, by covering it with a cloth or by placing it on a carpet.
Install the SMPS-628 as far as possible from a source of noise. (for example, refrigerator, microwave oven, fluorescent lamp, etc.)
Do not use the unit in places, which are extremely hot, cold, dusty or humid.
To reduce the risk of fire, do not place any heating or cooking appliance beneath this unit.
Stop operation immediately if any liquid or solid object should fall into the cabinet.
If the unit is not to be used for a long period of time, make sure that all power sources are disconnected from the unit. Remove all batteries from the battery compartment, and unplug the AC-DC adaptor from the wall outlet. Make it a practice to remove the AC-DC adaptor by grasping the plug and not by pulling the cord.
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
To establish a safe level:
 
Once you have established a comfortable sound level:
We Want You Listening For a Lifetime
Customer's Record:
Model Number : SMPS-628 Serial Number:
E-2
DEAR JENSEN® CUSTOMER
Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion and, most importantly, without affecting your sensitive hearing. Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of sound. So what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment at a safe level BEFORE your hearing adapts.
Start your volume control at a low setting.
Set the dial and leave it there. Taking a minute to do this now will help to prevent hearing damage or loss in the future. After all, we want you listening for a lifetime.
Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment. Since hearing damage from loud noise is often undetectable until it is too late, this manufacturer and the Electronic Industries Association's Consumer Electronics Group recommend you avoid prolonged exposure to excessive noise.
The serial number of this product is found on its back cover. You should note the serial number of this unit in the space provided as a permanent record of your purchase to aid in identification in the event of theft of loss.
Slowly increase the sound until you can hear it comfortably and clearly, and without
distortion.
E-3
Main Unit X 1AC adaptor X 1User Manual X 1Mounting kit X 1
PREPARATION FOR USE
LOCATION OF CONTROLS
14 15
16
17
13 12
1
23456 7 8 910
11
18 19
Unpack the unit carefully to remove all the accessories from the packing. Verify that the following accessories are present before setting up the unit.
Installing the unit under a cabinet
Accessories
LINE IN
1. Make the position of the 3 holes by using the supplied template. Use a drill to make the holes.
2. When the cabinet door overhangs the shelf and obstructs the unit, you can adjust the unit/shelf height.
3. Install the unit with the supplied mounting kit.
1
STANDBY BUTTON FM INDICATOR
LINE-IN INDICATOR
PM INDICATOR
TIMER INDICATOR
MEMORY INDICATOR
LINE IN JACK
DC IN JACK
LED LAMP
BATTERY COMPARTMENT
SPEAKER (L)
SPEAKER (R)
LIGHT BUTTON
SOURCE BUTTON
TIMER BUTTON
MEM / CLK BUTTON
TUNE - / SKIP - BUTTON
TUNE +/ SKIP + BUTTON
VOL - BUTTON
VOL + BUTTON
BLUETOOTH INDICATOR
BUTTON
BUTTON
13
214
3
15
416
5
17
6
18
7
19
8
20
9
21
10
22
11
23
CORD WRAP
24
NFC LINKING POINT
25
12
E-4
20 25
21
22
24
23
PAIR /
Loading...
+ 9 hidden pages