Jensen SMPS-125 User Manual

MODEL SMPS-125

PORTABLE STEREO SPEAKER SYSTEM

USER MANUAL

Please read this User Manual carefully before using the

unit and retain the Manual for future reference

WARNING



Do not throw the product into fire to avoid danger of explosion.

 No compensation responsibility for malfunctions caused by improper use.
 Do not attempt to disassemble or alter any part of the unit that is not expressly

described in this guide. Internal inspections, alternations and repairs should be
conducted by qualified service personnel.

IMPORTANT SAFETY INSTRUCTIONS

1. The apparatus and AC/DC adaptor shall not be exposed to dripping and splashing
and that no objects filled with liquids, such as vases, shall be placed on the
apparatus and AC/DC adaptor.

2. The mains plug of the AC/DC adapter is used as the disconnect device. The power
adaptor should always remain readily operable and should not be obstructed OR
should be easily accessed during intended use.

3. To completely disconnect the apparatus from supply mains, the mains plug of the
AC/DC adapter shall be disconnected from the mains socket outlet completely.

4. Minimum distances of 4 inches (10cm) around the apparatus and AC/DC adapter
shall be available for sufficient ventilation.

5. The ventilation should not be impeded by covering the ventilation openings with
items, such as newspapers, table-clothes, curtains, etc. ;

No naked flame sources such as lighted candles should be placed on the apparatus.

6. Attention should be drawn to environmental aspects of battery disposal.

7. The apparatus and AC/DC adapter should be used in moderate climates.

8. The rating plate of the apparatus is located on its bottom enclosure.

9. Battery (battery pack or battery installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.

CAUTION FOR LITHIUM BATTERY: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.

PROTECT YOUR FURNITURE!!

This system is equipped with non-skid rubber ‘feet’ to prevent the product from
moving when you operate the controls. These ‘feet’ are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber ‘feet’ to soften, and leave marks or a rubber
residue on the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase
small self-adhesive felt pads, available at hardware stores and home improvement
centers everywhere, and apply these pads to the bottom of the rubber ‘feet’ before
you place the product on fine wooden furniture.

2