Jenn-Air W10676382C User Manual

JENN-AIR® GAS COOKTOP

TABLE DE CUISSON À GAZ JENN-AIR

W10676382C

Use & Care Guide

For questions about features, operation/performance, parts, accessories, or service in the U.S.A., call:

Au Canada, pour assistance, installation ou service, composez le 1-800-JENNAIR (1-800-536-6247) ou visitez notre site web à

1-800-JENNAIR (1-800-536-6247) or visit our website at www.jennair.com.

In Canada, call: 1-800-JENNAIR (1-800-536-6247), or visit our website at www.jennair.ca.

Guide d’utilisation et d’entretien

www.jennair.ca.

Table of Contents/Table des matières ...................2

You can be killed or seriously injured if you don't immediately

You

can be killed or seriously injured if you don't

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

follow instructions.

instructions.

DANGER

WARNING

COOKTOP SAFETY........................................................................2

PARTS AND FEATURES................................................................4

COOKTOP USE ..............................................................................5

Cooktop Controls.........................................................................5

Sealed Surface Burners ...............................................................5

Melt Cap.......................................................................................6

Surface Grates .............................................................................6

Home Canning .............................................................................7

Cookware .....................................................................................7

COOKTOP CARE............................................................................7

General Cleaning..........................................................................7

TROUBLESHOOTING ....................................................................8

ASSISTANCE OR SERVICE...........................................................9

In the U.S.A. .................................................................................9

Accessories..................................................................................9

In Canada .....................................................................................9

WARRANTY ..................................................................................10

COOKTOP SAFETY

TABLE DES MATIÈRES

SÉCURITÉ DE LA TABLE DE CUISSON ....................................11

PIÈCES ET CARACTÉRISTIQUES ..............................................13

UTILISATION DE LA TABLE DE CUISSON................................14

Commandes de la table de cuisson ..........................................14

Brûleurs de surface scellés ........................................................14

Chapeau pour faire fondre .........................................................15

Grilles de surface........................................................................15

Préparation de conserves à la maison.......................................16

Ustensiles de cuisson ................................................................16

ENTRETIEN DE LA TABLE DE CUISSON ..................................16

Nettoyage général ......................................................................16

DÉPANNAGE.................................................................................17

ASSISTANCE OU SERVICE.........................................................18

Au Canada..................................................................................18

Accessoires ................................................................................18

GARANTIE.....................................................................................19

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this

or any other appliance.

– WHAT TO DO IF YOU SMELL GAS:

•

Do not try to light any appliance.

•

Do not touch any electrical switch.

•

Do not use any phone in your building.

•

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•

If you cannot reach your gas supplier, call the fire department.

– Installation and service must be performed by a qualified installer, service agency or

the gas supplier.

WARNING: Gas leaks cannot always be detected by smell. Gas suppliers recommend that you use a gas detector approved by UL or CSA. For more information, contact your gas supplier. If a gas leak is detected, follow the “What to do if you smell gas” instructions.

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To reduce the risk of fire, electrical shock,

injury to persons, or damage when using the cooktop, follow basic precautions, including the following:

■ WARNING: NEVER use this appliance as a space

heater to heat or warm the room. Doing so may result in carbon monoxide poisoning and overheating of the cooktop.

■ CAUTION: Do not store items of interest to children in

cabinets above the cooktop – children climbing on the cooktop to reach items could be seriously injured.

■ Proper Installation – The cooktop, when installed, must be

electrically grounded in accordance with local codes or, in the absence of local codes, with the

National Electrical Code, ANSI/NFPA70 or the Canadian Electrical Code, Part 1

. Be sure the cooktop is properly installed and

grounded by a qualified technician.

■ This cooktop is equipped with a three-prong grounding

plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.

■ Disconnect the electrical supply before servicing the

cooktop.

■ Injuries may result from the misuse of the cooktop such as

stepping, leaning, or sitting on the top surface.

■ Maintenance – Keep cooktop area clear and free from

combustible materials, gasoline, and other flammable vapors and liquids.

■ Storage on the cooktop – Flammable materials should not

be stored on or near surface units.

■ Top burner flame size should be adjusted so it does not

extend beyond the edge of the cooking utensil.

State of California Proposition 65 Warnings: WARNING: This product contains one or more chemicals known to the State of California to cause cancer. WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other

reproductive harm.

PARTS AND FEATURES

JKL

This manual covers different models. The cooktop you have purchased may have some or all of the items listed. The locations and appearances of the features shown here may not match those of your model.

30" (76.2 cm) and 36" (91.4 cm) Cooktops

IMPORTANT: See “Sealed Surface Burners” in the “Cooktop Use” section for proper burner base and cap positioning. Do not

interchange burner caps.

A. Surface burner grate B. Dual burner C. Surface burner cap

and base

D. Small burner

E. Medium burner

F. Control panel G. Right front control knob H. Right rear control knob

I. Center control knob

J. Left rear control knob

K. Left front control knob

L. Surface burner locator

M. Large burner

N. Large burner

COOKTOP USE

WARNING

Fire Hazard

Do not let the burner flame extend beyond the edge of the pan.

Turn off all controls when not cooking. Failure to follow these instructions can result in death

or fire.

REMEMBER: When cooktop is in use, the entire cooktop area may become hot.

Cooktop Controls

Electric igniters automatically light the surface burners when control knobs are turned to HI and will automatically reignite if the flame is extinguished.

If a cross draft is present, the flame may be affected and some sparking may occur. This is normal.

Before setting a control knob, place filled cookware on the grate. Do not operate a burner using empty cookware or without cookware on the grate.

To S et :

1. Push in and turn knob counterclockwise to HI.

2. Turn knob to anywhere between HI and LO. Use the following

chart as a guide when setting heat levels.

SETTING RECOMMENDED USE

HI ■ Start food cooking.

■ Bring liquid to a boil.

■ Hold a rapid boil.

■ Quickly brown or sear food.

■ Fry chicken.

Medium Between HI and LO

■ Maintain a slow boil.

■ Fry or sauté foods.

■ Cook soups, sauces and gravies.

■ Stew or steam food.

Power failure

In case of power failure, the surface burners can be lit manually. Hold a lit match near a burner and turn knob counterclockwise to HI. After burner lights, turn knob to setting.

IMPORTANT: Burner reignition feature does not work without power.

Sealed Surface Burners

Standard Burner

A. Cap B. Spreader C. Electrode

Burner installation:

To install the burner base, insert the igniter electrode into the burner base hole or notch.

IMPORTANT: Do not obstruct the flow of combustion and ventilation air around the burner grate edges.

Burner cap: Always keep the burner cap in place when using a surface burner. A clean burner cap will help avoid poor ignition and uneven flames. Always clean the burner cap after a spillover and routinely remove and clean the caps according to the “General Cleaning” section.

Gas tube opening: Gas must flow freely throughout the gas tube opening for the burner to light properly. Keep this area free of soil and do not allow spills, food, cleaning agents or any other material to enter the gas tube opening. Keep spillovers out of gas tube by always using a burner cap.

Dual Flame Burner

A. Cap B. Spreader C. Electrode

Simmer

*For a more delicate simmer, see the “Melt Cap” section.

■ Simmer.*

■ Keep food warm.

■ Simmer sauces.

Burner ports: Check burner flames occasionally for proper size

and shape. A good flame is blue in color, not yellow. Keep this area free of soil and do not allow spills, food, cleaning agents or any other material to enter the burner ports.

4. Turn on the burner. If the burner does not light, check burner

cap and base alignment. See “Burner installation” in the “Sealed Surface Burners” section. If the burner still does not light, do not service the burner yourself. Contact a trained repair specialist.

Standard burner

A. Low flame B. High flame

Dual flame burner

A. Simmer flame B. High flame

To C le an:

IMPORTANT: Before cleaning, make sure all controls are off and

cooktop is cool. Do not use oven cleaners, bleach or rust removers.

1. Remove the burner cap from the burner base and clean

according to “General Cleaning” section.

2. Clean the gas tube opening with a damp cloth.

3. Replace burner bases and burner caps. IMPORTANT:

■ Be sure that the igniter electrode aligns with the slot or

notch in the burner base. The igniter electrode is ceramic and could break during installation of the burner base.

A. Correct B. Incorrect

Melt Cap

For melting chocolate or butter or an even more delicate simmer, the melt cap can be used in place of the standard burner cap. The melt cap should only be used on the small burner (right rear). Remove the small burner cap and replace it with the larger melt cap for delicate simmering. For less delicate simmering, use the small cap.

Surface Grates

The surface grates are positioned correctly when the thick ribs form a frame around the outer edge and the thin ribs are located across the middle. All burners will be centered with the burner openings in the grates. See the following illustration.

NOTE: The end grates are different than the center grate. Do not use the end grate in the center grate position. End grates have a tab that prevents interchanging the center and end grates. Install the end grate first with the tab facing the center burner. Then install the center grate.

A. Burner cap B. Igniter electrode C. Burner base

■ Be sure that the cap is properly positioned on the burner

and that you have placed the cap on the correct burner. The ring on the bottom of the cap will align with the tabs on the burner. Do not interchange caps.

Dual flame burner cap Standard burner cap Small burner cap

A. Thick ribs B. Thin ribs

C. End grates D. Center grate

+ 14 hidden pages