Jenn-Air MK7048, MK7036, MK7030 User Manual
RANGE HOOD
Model Number: JXT9030CDP JXT9036CDP JXT9048CDP
Manufacturer Number: MK7030 MK7036 MK7048
Size: 30” 36” 48”
USER
GUIDE
TABLE OF CONTENTS
Safety Instructions.................................................... 1
Controls & Features................................................. 2
Maintenance.........................................................3-4
Warranty...................................................................5
MK7030
MK7036
MK7048
Form No. A/06/04 Part No. 8110P261-60 ©2004 Maytag Appliances Sales Co. Litho U.S.A.
USE AND CARE GUIDE
Read all Instructions before Installing and operating this appliance
MODELS: JXT9030 JXT9036 JXT9048
IMPORTANT SAFETY NOTICE
WARNING
Installation
The installation in this manual is intended for qualified installers, service technicians or persons
with similar qualified background. DO NOT attempt to install this appliance yourself. Injury could
result from installing the unit due to lack of appropriate electrical and technical background.
All electrical wiring must be properly installed, insulated and grounded. Overly accumulated
grease in old duct work should be cleaned out or duct work should be replaced if necessary to
avoid the possibility of a grease fire. Check all joints on duct work to insure proper connection
and all joints should be properly taped.
Operations
Read all instructions in this manual before operating the appliance. Save these instructions for
future reference.
Always leave safety grills and filters in place. Without these components, operating blowers
could catch on to hair, fingers and loose clothing.
NEVER dispose cigarette ashes, ignitable substances, or any foreign objects into blowers.
NEVER leave cooking unattended. When frying, oil in the pan can easily overheat and catch fire.
The risk of self combustion is higher when the oil has been used several times.
Cleaning
The saturation of greasy residue in the blower and filters may cause increased flammability.
Keep unit clean and free of grease and residue build-up at all times to prevent possible fires.
Filters must be cleaned periodically and kept free from accumulation of cooking residue (see
cleaning instructions inside). Old and worn filters must be replaced immediately. Do not operate
blowers when filters are removed. Never disassemble parts to clean without proper instructions.
Disassembly is recommended to be performed by qualified personnel only.Call our service cen-
ter for removal instructions. 1-800-JENNAIR (USA and Canada), (1-800-536-6247)
The manufacturer declines all responsibility in the event of failure to observe the instructions given here for installation, maintenance and suitable use of the product. The manufacturer further declines all responsibility for injury due to negligence and the warranty of the
unit automatically expires due to improper maintenance.
* Please check for latest specification revisions before any custom work or cutouts.
CONTROLS & FEATURES
Adjust 6 Speed Levels
2
15 Minutes Delay Off
3
Blower On/Off
1
Lights On/Off/Dim
4
CONTROLS & FEATURES
1
Blower On/Off
By pressing , the blower is switched On and Off.
2
2
Speed Selection
The 6 speed levels are selected by pressing to decrease and to increase speed level.
The display indicates level selected.
3
Delay Off
This is used for programmed shut down of blower and lights 15 minutes after the function is activated. After pressing , the hood will completely shut down in 15 minutes.
4
Lights On/Off/Dim
Switch lights On and Off by pressing once. To dim lights, press and hold for 2 seconds.
MAINTENANCE
3
CLEANING
Surface Maintenance:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent (e.g. Comet powder scrub, Easy Off oven cleaner), or steel wool/scouring pads which will
scratch and damage surface.
For heavier soil use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
After cleaning, you may use non abrasive stainless steel polish/ cleaners such as 3M or ZEP,
to polish and buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth,
and with the grain.
Stainless Steel Baffled Filters
The stainless steel baffled filters fitted by the factory are intended to trap residue and grease from
cooking. Although the filters never need replacement, they are required to be kept clean. Filters
should be cleaned after every 30 hours of use.
Removing Baffled Filters
1. Pull filter toward back of range hood using handles.
2. Pivot filter front upward.
3. Remove downwards to the rear.
30” - 2 filters
36” - 3 filters
48” - 4 filters
MAINTENANCE
LIGHTS
Replacing Light Bulbs
CAUTION: Light bulb becomes extremely hot when turned on.
DO NOT touch bulb until switched off and cooled. Touching hot
bulbs could cause serious burns.
Make sure all power is turned off and
bulbs are not hot.
Remove by turning bulb counterclockwise.
If bulbs are difficult to remove due to prolonged use, firmly attach a glass suction cup
(readily available at most lighting stores)
approximately the diameter of the bulb and
turn counter clockwise. You may also use a
rubber or latex glove to get the same effect.
Replacement bulbs are available at specialty
lighting stores. Purchase type GU10 120V
50W halogen bulbs.
Or to order bulbs, please call our service
1-800-JENNAIR (1-800-536-6247)
center:
4
30” - 2 bulbs
36” - 3 bulbs
48” - 4 bulbs
OPTIONAL ACCESSORIES
Model: JXT9030CDP JXT9036CDP JXT9048CDP
Back Splash JXA9003CDP JXA9002CDP JXA9001CDP
12” Duct Cover JXA9030CDP JXA9036CDP JXA9048CDP
WARRANTY
5
Warranty:
Full One Year Warranty - Parts and Labor
For one (1) year from the original retail purchase date, any part which fails in normal
home use will be repaired or replaced free of
charge.
Limited Warranty - Parts Only
Second Year -
original purchase date, parts which fail in normal home use will be repaired or replaced free
of charge for the part itself, with the owner
paying all other costs, including labor, mileage
and transportation, trip change and diagnostic
charge, if required.
Canadian Residents
The above warranties only cover an appliance
installed in Canada that has been certified or
listed by appropriate test agencies for compliance to a National Standard of Canada unless
the appliance was brought into Canada due to
transfer of residence from the United States to
Canada.
The specific warranties expressed above are the
ONLY warranties provided by the manufacturer.
These warranties give you specific legal rights, and
you may also have other rights which vary from
state to state.
After the first year from the
What is Not Covered By These Warranties:
1. Conditions and damages resulting from any of the following:
a. Improper installation, delivery, or maintenance.
b. Any repair, modification, alteration, or adjustment not authorized
by the manufacturer or an authorized servicer.
c. Misuse, abuse, accidents, or unreasonable use.
d. Incorrect electric current, voltage, or supply.
e. Improper setting of any control.
2. Warranties are void if the original serial numbers have been removed,
altered, or cannot be readily determined.
3. Light bulbs.
4. Products purchased for commercial or industrial use.
5. The cost of service or service call to:
a. Correct installation errors.
b. Instruct the user on the proper use of the product.
c. Transport the appliance to the servicer.
6. Consequential or incidental damages sustained by any person as a
result of any breach of these warranties. Some states do not allow the
exclusion or limitation of consequential or incidental damages, so the
above exclusion may not apply.
If You Need Service
• Call the dealer from whom your appliance was purchased or call
Maytag ServicesSM, Jenn-Air Customer Assistance at 1-800-JENNAIR
(1-800-536-6247) USA and CANADA to locate an authorized servicer.
• Be sure to retain proof of purchase to verify warranty status. Refer to
WARRANTY for further information on owner’s responsibilities for warranty
service.
• If the dealer or service company cannot resolve the problem, write to
Maytag Services
37320-2370, or call 1-800-JENNAIR (1-800-536-6247) USA and CANADA.
U.S. customers using TTY for deaf, hearing impaired or speech
impaired, call 1-800-688-2080.
NOTE: When writing or calling about a service problem, please include the
following information:
a.Your name, address and telephone number;
b. Model number and serial number;
c. Name and address of your dealer or servicer;
d. A clear description of the problem you are having;
e. Proof of purchase (sales receipt)
• User’s guides, service manuals and parts information are available from
Maytag Services
SM
, Attn:CAIR® Center, P.O. Box 2370, Cleveland, TN
SM
, Jenn-Air Customer Assistance.
Loading...