Jenn-Air MK2167, MK2160 Installation Instructions Manual

MICROWAVE OVEN BUILT-INTRIM
KIT
INSTALLATIONINSTRUCTIONS
Built-In Trim Kit Models MK2167, MK2160
UL listed for use over any electric or gas built-in electric oven, up to 30" (76.2 cm) wide
INSTRUCTIONSD'INSTALLATION
GARNITUREENCASTREEPOURFOURA MICRO-ONDES
Garniture encastrde pour modules MK2167, MK2160
Table of Contents / Tabledes mati@res
MICROWAVE OVEN SAFETY ................................................... 1
INSTALLATION INSTRUCTIONS .............................................. 2
Tools and Parts ....................................................................... 2
Location Requirements ........................................................... 2
Required Cutout Dimensions .................................................. 2
Trim Kit Frame Dimensions ..................................................... 2
Electrical Requirements .......................................................... 3
Prepare Microwave Oven ........................................................ 3
Prepare Cutout/Cabinet Opening ........................................... 3
Install the Microwave Oven ..................................................... 4
Install Trim Kit Frame .............................................................. 5
SECURITE DU FOUR A MICRO-ONDES .......................................... 7
INSTRUCTIONS D'INSTALLATION ................................................... 7
Outillage et pieces ............................................................................ 7
Exigences d'emplacement ............................................................... 7
Dimensions necessaires de I'ouverture d'encastrement ................. 8
Dimensions du cadre de la trousse de garniture ............................. 8
Specifications electriques ................................................................ 8
Preparation du four & micro-ondes .................................................. 9
Preparation de I'ouverture d'encastrement ..................................... 9
Installation du four & micro-ondes ................................................. 10
Installation du cadre de la trousse de garniture ............................ 11
MICROWAVE OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
W10434122A
INSTALLATIONINSTRUCTIONS
t'O0_S 3_J
Tools Needed Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Measuring tape Drill
Pencil 7/64" drill bit
Phillips screwdriver
Parts Supplied (not shown to scale
Rails (2)
t_
Short screws (14)
(11+ 3 extra)
Bottom duct Trimkit frame
Long wood screws (6 - painted)
(4 + 2 extra)
, ,4
(2.7 cm)
!
17" (43 2 cm) _
mln.
171/8 ,,
max.
3 II
NOTES:
Height dimension is critical: 17" (43.2 cm)minimum, 17V8" (43.5 cm) maximum.
Width and depth measurements have _+1/16" (2 mm) tolerance.
3" (7.6 cm) minimum dimension is from lower oven cutout ceiling to microwave oven cutout floor.
Trim kit frame extends 1Vld' (2.7 cm) above and below the cutout opening.
_, 23 Vs" (58.7 cm)._--
1%6"
(2.7 cm)
liiii;i_;ii_;ii_;ii(t B
A. Trim kit frame overhang B. Cutout for lower oven
x
XA
' _ _,_ Ii_ _ _ '_ _
Locust( n @ @qu ®ments
The microwave oven may be installed over a built-in oven. If installing over a built-in oven, make sure there is a minimum of 3" (7.6 cm) between the top of the lower oven cutout and the
microwave oven cutout floor. The microwave oven may also be installed in a cabinet by itself
(without a built-in oven below). For best usability, we recommend a minimum distance of 36" (91.4 cm) from the floor to the cutout
floor. Make sure the surrounding cabinetry has clearance to open and
close freely. Allow a clearance of at least 1%d' (4.0 cm) below the cutout floor (3" [7.6 cm] for installation above a built-in oven), and
a clearance of at least 2" (5.1 cm) above the cutout opening.
2 II
(5.1cm)
1 9/16"
2 II
crn)
3 II
I 26 7/a" (68.2 cm)*
,1 29 3/4" (75.6 cm)**
T _ 22 3/4" (57.8 cm) --
19 %" (8.7 cm)
(48.6 cm] 12 1/4"
__ 2 V_d' (5.2 cm)*
3 V_" (8.9 cm)**
3 7A6" I
(31 Jim)
1 3A6" (3.0 cm)
*27" (68.6 cm) trim kit
**30" (76.2 cm) trim kit
.I
A. Upper cabinet D. Lower cabinets
B. Microwave oven cutout E.Floor
C. Lower oven cutout
2
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter.
Do not use an extension cord. Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING iNSTRUCTiONS
[] For all cord connected appliances:
The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified electrician or serviceman ifthe grounding instructions are
not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
1. Unplug microwave oven before proceeding with installation.
2. Remove any loose items inside microwave oven.
3. Gently turn microwave oven onto its top, with the door facing forward (toward installer).
4. Align the two rails on the microwave oven bottom, as shown, making sure the flanges are forward and pointing up.
A B C
D E
A. Rails (2) D. Flanges B. Microwave oven bottom E.Door
C. Short screws (4)
5=
Secure the rails to the microwave oven bottom using four short screws.
,,.....,,, e l Opes og
1=
On the cutout floor, find and mark the centerline.
2.
Place the bottom duct in the opening, with the flange resting against the bottom front facing of the opening.
A B C
SAVE THESE iNSTRUCTiONS
D
A. Cutout floor B. Centerline C. Bottom duct
E
D. Bottom duct flange
E. Front facing
3. Align the center arrows on the bottom duct with the centerline drawn in Step 1 above.
/////
A B
A.Bottom duct B.Center arrows, aligned with centerline
4=
Mark the three mounting holes through the bottom duct onto the cutout floor.
?
I I I I
I I
1. Gently return microwave oven to its upright position.
2. Position microwave oven near cutout opening.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong. Do not use an adapter.
Do not use an extension cord. Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug in microwave oven.
4. Align the rails with the rail guides on the bottom duct.
g
A. Short screws (3) B. Bottom duct mounting holes
5. Using 7/64" drill, drill pilot holes into the three holes marked in Step 4.
6. Realign and install the bottom duct with three short screws.
7. Using 7/64" drill, drill pilot holes through the four mounting holes of the bottom duct flange into the bottom front facing of
the cutout/cabinet opening.
A B
A. Bottom duct flange B. Mounting holes
Loading...
+ 8 hidden pages