Jenn-air JXA9001CDP Installation

BACKSPLASH
Model Number: JXA9003CDP JXA9002CDP JXA9001CDP Size: 30” 36” 48”
INSTALLATION
GUIDE
TABLE OF CONTENTS
List of Materials...........................................................1
Installation...............................................................2-3
Form No. A/06/04 Part No. 8110P266-60 ©2004 Maytag Appliances Sales Co. Litho U.S.A.
LIST OF MATERIALS
1 - Upper section 1 - Lower section 2 - Warming shelves/spice racks 1 - Bag of mounting hardware including:
2 - Retaining clips 4 - Hinge clips 6 - 7/16” carriage head bolt 8 - 5/8” philips head wood screw 6 - carriage head bolt nuts
1
INSTALLATION
2
INSTALLATION INSTRUCTIONS
Note: This backsplash must be installed before the hood shell. The hood shell covers the mounting
screws at the top of the backsplash.
1. Mark a level line on the wall at 16” below bottom of hood location.
2. Position the lower section of backsplash (flat part with flange at top) on the wall. Center it side to side and mark the top and bottom holes. Remove the lower section from the drywall.
3. Insert wall anchors into the marked holes. (We recommend drywall E-Z anchors)
4. Attach lower section of backsplash to wall with screws provided.
5. Position upper section of backsplash by engaging its flange with the lower section. Push up to fully engage flanges, center it side to side, and mark the location of the mounting holes. Remove the upper section from the drywall.
6. Insert wall anchors into the marked holes. (We recommend drywall E-Z anchors)
7. Insert the retaining clips and hinge clips to the upper section. The retaining clips go in the top two openings and the hinge clips go in the bottom four openings. Fasten and tighten the clips to the back of the upper section with the nuts provided.
8. Attach upper section to wall with screws provided.
INSTALLATION
ATTACH WARMING SHELVES
1. Snap the warming shelves into the hinge clips on the backsplash as shown in the left shelf diagram.
2. If narrower shelves are desired: attach shelf to hinge clips only, as shown in the right shelf diagram, then rotate shelf upwards and secure with retaining clip.
3
Loading...
+ 8 hidden pages