JENN-AIR® DETAILED PLANNING DIMENSIONS
buILT-IN/cOuNTERTOP MIcROwAvE OvEN
JMC1116A – 213⁄4" x 13" x 173⁄4"
PRODucT DIMENSIONS
MODEL # JMC1116A
Overall width 21
D
B C
FRONT VIEW
A
A
Width of door 17
B
Width of control panel 4 10.2
C
Overall height 13 33.0
D
Depth of cabinet with door 16 40.6
E
Overall depth with door 17
F
Depth with door open 90° 34
G
1 of 2
in cm
3
/4 55.3
3
/4 45.1
3
/4 45.1
3
/4 88.3
TOp VIEW
E
F
G
G
F
E
D
Wall
SIDE VIEW
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JRC120106 07/2012
JENN-AIR® DETAILED PLANNING DIMENSIONS
buILT-IN/cOuNTERTOP MIcROwAvE OvEN
JMC1116A – 213⁄4" x 13" x 173⁄4"
OPENING/cLEARANcE DIMENSIONS
MODEL # JMC1116A
Width of cutout 23
A
Height of cutout (min.-max.) 17-17
B
Top of cutout to bottom
C
of upper cabinet (min.)
C
e
B
D
A
F
Bottom of cutout to
top of single oven (min.)
D
Bottom of cutout to
top of cabinet door (min.)
Recommended height from
E
bottom of cutout to floor
Depth of cutout (min.) 22
F
e
Recommended electrical connection location
Note: Trim kit frame extends 1
the cutout opening.
in cm
1
/8 58.7
1
/8 43.2-43.5
2 5.1
3 7.6
5
1
/8 4.0
36 91.4
3
/4 57.8
1
/16" (2.7 cm) above and below
2 of 2
FRONT VIEW
TRIM KIT DIMENSIONS
B
ELECTRICAL REQUIREMENTS
E
120 volt, 60 Hz, AC only, 15- or 20-amp fused, electrical supply
is required. A time-delay fuse or dedicated circuit is recommended.
Minimum length of power cord is 30" (76.2 cm). Do not use
an extension cord.
VENTING REQUIREMENTS
If microwave oven is built in, a trim kit is required for proper ventilation.
SIDE VIEW
G
MODEL # MK2160 MK2167
in cm in cm
3
Overall width 29
A
Width of opening 22¾ 57.8 22¾ 57.8
C
E
F
D
B
Height of opening 12¼ 31.1 12¼ 31.1
C
Width of frame 3½ 8.9 2
D
Overall height 19
E
Height of frame 3
F
Depth of frame 1
G
/4 75.6 267/8 68.2
1
/16 5.2
1
/8 48.6 191/8 48.6
7
/16 8.7 37/16 8.7
3
/16 3.0 13/16 3.0
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JRC120106 07/2012