JennAir JKRPL151HL, JKRPL151HM Installation Guide
INSTALLATION INSTRUCTIONS
A
B
for JennAir® Ice Maker RISE™ Stainless Steel Panel Accessory
Use the materials in this accessory kit to install the RISE™
stainless steel panel by following the installation instructions.
Before you begin:
A qualied service technician must perform installation.
Panel Accessory contains:
1. Front Panel and Handle Assembly
2. Screws (2)— #8-15 X .813 HW A
Tools required:
1. Phillips Screwdriver
2. Flat Head Screwdriver
3. Diagonal Cutting Plier
Installation Procedure
1. Remove the screws attaching hinge covers using the at
head screwdriver.
4. Remove screws (3) from the top and bottom metal brackets
using the Phillips screwdriver. Remove and discard metal
brackets and holding screws.
5. Slide new front panel assembly on the Ice Maker door from
the top.
2. Remove the hinge cover from upper and lower hinges.
A. Upper hinge cover
B. Lower hinge cover
3. To remove, cut hinge cover at indicated point using diagonal
cutting plier and remove from hinges.
1
6. Use #8-15 X .813 HW A screws (2) with the Phillips
screwdriver to x mount the front panel assembly.
Front panel
and
Handle
assembly
7. Refer Installation Instruction supplied with unit for nal
installation.
Loading...