JJW9730
Dimensions
|
Inches |
Centimeters |
A |
25 minimum |
63.5 minimum |
B |
24 minimum |
61.0 minimum |
C |
28 1/2 |
72.4 |
D |
18 1/2 |
47.0 |
E |
23 minimum |
58.4 minimum |
F |
29 7/8 |
75.9 |
G |
18 7/8 |
47.9 |
H |
18 1/8 |
46.0 |
|
|
|
I |
28 |
71.1 |
J |
22 13/16 |
57.9 |
|
|
|
K |
1 5/8 |
4.1 |
|
|
|
Notes:
1.2" diameter conduit access hole located on back panel 3" in from left side and 3 1/2" up from bottom.
2.5/8" plywood floor (must support approx. 185 lbs.)
U.Center line of cabinet cutout is not the center line of the oven face. The cutout is offset by 5/16" to the right as you face the cutout.
V.Minimum clearance required is dimension from bottom of cooktop burner box to bottom of countertop plus one inch. Dimensions vary per cooktop.
W.Allow for 15/16" face trim overlap on each side.
X.Gas connection for cooktop must be located in adjacent left accessible location.
Y.Gas or electric cooktop may be installed over oven. See cooktop installation instructions for cutout size.
Z.Do not block air intake vents at bottom of oven.
Installation: The Jenn-Air® Accellis™ 5XP wall oven requires a dedicated 220/240-volt 30-amp circuit to operate. The unit also must be installed on a solid cabinet floor that will support approximately 175 pounds.
Important: Because of continuing product improvements, Jenn-Air reserves the right to change specifications without notice. Dimensional specifications are provided for planning purposes only. For complete details see installation instructions that accompany each product before selecting cabinetry, making cutouts or beginning installation.
Loading...