JENN-AIR JGW8130ADB, JGW8130ADW, JGW9130ADB, JGW9130ADW Dimension Guide
www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600
This Data Sheet Includes Information On
Jenn-Air
• Product Model Number (s): •
30" Gas Single Wall Ovens:
JGW8130ADB, JGW8130ADW, JGW9130ADW and
JGW9130ADB
• Dimensions (Actual Size) •
Minimum cabinet width:
Minimum cut-out opening width:
Minimum cut-out opening height:
Recommended cutout location from floor :
Minimum inside cabinet depth:
33"
30 1/8"
33 3/4"
12" Min.
24"
Distance from face of cabinet to
outer edge of open door(s):
20 1/2"
Distance from face of cabinet to
front of closed door handle:
Overall unit width:
Overall unit height:
Penetration into cabinet:
5/16"
30 7/8"
34"
23 7/8"
Distance from face of cabinet
to centerline of gas inlet:
Distance (right) from centerline to gas inlet:
2 1/4"
6 1/16"
Oven overlap distances when using
cutout dimensions listed above:
Top overlap:
Bottom overlap:
Right side overlap:
1/4"
0"
3/8"
Left side overlap: 3/8"
• Additional Information •
• Cutout height and width are ± 1/16".
• Cutout in cabinet should be level and straight. There
are no provisions to level the unit after it is installed.
• Construct 5/8" minimum plywood floor flush with
bottom of opening. Floor must be level and straight and
capable of supporting 250 lbs.
• Electrical supply : 20 amp, 120 VAC polarized
electrical supply above the oven.
• Gas supply : Can be connected to either LP or natural
gas. Inlet pressures for LP gas: Min 11WC, Max
14WC. Inlet pressures for Natural gas: Min 5WC, Max
14WC.
• For European style cabinets (flush front) the required
clearance for operation of the oven door is a minimum
spacing of 7/8" between the cutout and the door, hinge
or drawer of the cabinet.
Cabinet Openings
(not to scale)
33 3/4"
12" Min.
30 1/8"
2 1/4"
33"
6 1/16"
C
L
20amp, 120 VAC polarized
electric supply location
Cutout for electrical cord
receptacle to be sealed
after installation
2" Diameter minimum hole
for 3/8" N.P.T. inlet pipe to
be sealed after installation
C
L
Solid cabinet
bottom required
24"
Overall Dimensions
(not to scale)
34"
Subject to change without notice. This system is designed to
23 7/8"
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of determining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2002.
• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at (775) 833-3633 •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.
202
5/16"
30 7/8"
BN207.5 • A202 • • 032603 • 95656 • 69203
Loading...