How it Works
Jenn-Air
Loading...
JGC2536EB00
Installation Guide
10 pgs3.18 Mb0
Owner’s Manual
13 pgs7.64 Mb0

Jenn-Air JGC2530EB00, JGC2536EB00 Installation Guide

30" (76.2 CM) AND 36" (91.4 CM) GAS BUILT-IN
IMPORTANT:
Installer: Homeo
IMPOR
Installateur Pr
.
COOKTOP INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION DE LA
TABLE DE CUISSON À GAZ ENCASTRÉE
DE 30" (76,2 CM) ET DE 36" (91,4 CM)
Table of Contents/Table des matières
COOKTOP SAFETY ........................................................................1
INSTALLATION REQUIREMENTS .................................................3
INSTALLATION INSTRUCTIONS ...................................................6
WIRING DIAGRAM .........................................................................9
SÉCURITÉ DE LA TABLE DE CUISSON .....................................10
EXIGENCES D’INSTALLATION ...................................................11
Outillage et pièces ......................................................................11
Exigences d’emplacement .........................................................11
Spécifications électriques ..........................................................13
Spécifications de l’alimentation en gaz .....................................13
INSTRUCTIONS D’INSTALLATION .............................................15
Préparation de la table de cuisson pour l’installation................15
Installation de la table de cuisson ..............................................15
Raccordement au gaz ................................................................16
Achever l’installation ..................................................................17
SCHÉMA DE CÂBLAGE ...............................................................18
COOKTOP SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
DANGER
follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
opriétaire : Conserver les instructions d'installation pour référence ultérieure
W10821219A
WARNING
Leave installation instructions with the homeowner.
wner: Keep installation instructions for future reference.
TANT :
: Remettre les instructions d'installation au propriétaire.
You
can be killed or seriously injured if you don't
instructions.
follow
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the “What to do if you smell gas” instructions.
IMPORTANT: Do not install a ventilation system that blows air downward toward this gas cooking appliance. This type of ventilation system may cause ignition and combustion problems with this gas cooking appliance resulting in personal injury or unintended operation.
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
•
instructions. If you cannot reach your gas supplier, call the fire department.
•
– Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
In the State of Massachusetts, the following installation instructions apply:
■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
■ If using a ball valve, it shall be a T-handle type.
■ A flexible gas connector, when used, must not exceed 3 feet.
2
INSTALLATION REQUIREMENTS
C
C
A
B
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed
■ Tape measure
■ Flat-blade screwdriver
15
■
⁄16" (24 mm) combination
wrench
■ Pipe wrench
■ Channel lock pliers
Parts supplied
■ Gas pressure regulator
■ Burner grates: common (4), center (1)
■ Burner bases (5)
■ Burner caps (5)
■ Simmer cap
■ Clamp brackets (2)
2
■ 2¹⁄
" (6.4 cm) clamping screws (2)
■ Foam tape seal
■ LP conversion kit - W10686634
Parts needed
Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.
■ Marker or pencil
■ Pipe-joint compound
resistant to LP gas
■ Noncorrosive leak-detection
solution
IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.
Mobile Home - Additional Installation Requirements
The installation of this cooktop must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this cooktop must conform with the current standards CAN/CSA-A240-latest edition, or with local codes.
Product Dimensions
A
B
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air.
■ It is the installer’s responsibility to comply with installation
clearances specified on the model/serial/rating plate. The model/serial/rating plate is located on the underside of the cooktop burner box.
■ Do not unpack the burner grates and bases until after the
cooktop is installed to avoid scratching the cooktop.
■ To eliminate the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
■ The cooktop should be installed in a location away from
strong draft areas, such as windows, doors and strong heating vents or fans.
■ All openings in the wall or floor where cooktop is to be
installed must be sealed.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Proper gas supply connection must be available. See “Gas
Supply Requirements” section.
■ The gas and electric supply should be located as shown in
“Gas and Electric Connection Locations” in the “Location Requirements” section so that they are accessible without requiring removal of the cooktop.
A. *21" (53.3 cm) B. *30" (76.2 cm) on 30" (76.2 cm) models
36" (91.4 cm) on 36" (91.4 cm) models C. 31/4" (8.3 cm) *Metal tabs should not be bent during installation
Gas and Electric Connection Locations
D
A. Gas pressure regulator (supplied) - arrow pointed
toward cooktop B. 3 prong grounding type outlet with correct polarity C. Gas shutoff valve D. 18" (45.7 cm) minimum
3
Loading...
+ 7 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use