JENN-AIR JFI2089ATS Installation Instructions

Ice and Water Decorator Panel Installation

28"

711 mm

1 5/8"

41 mm

15 1/8"

384 mm

1 5/8"

41 mm

260mm

6 1/16"

154 mm

10 1/4"

5 23/32" 145 mm

23 9/16" 598 mm

1 27/32"

47 mm

17 19/32"

447mm

29 31/32

762 mm

7 1/32"

179 mm

44 3/32"

1120 mm

REMOVING DISPENSER (Reverse procedure to install.)

1/4"

hex driver

1/4" hole typ.

6.3 mm

35 21/32"

906 mm

21 1/2"

546 mm

WEIGHT REQUIREMENTS FOR PANEL INSERTS

•

Individual refrigerator door panels should not exceed 15 lbs. (7 kg).

•

Freezer drawer panel should not exceed 15 lbs. (7 kg).

INST ALLING AND REMOVING HANDLES

REMOVING HANDLES

1. Locate set screws (A) in handle and loosen set screws with a 3/32" Allen wrench.

2. Lift handle from handle mounting posts to remove.

3. Remove handle mounting posts (B) with a Torx-20 driver.

INSTALLING HANDLES

1. Install handle mounting posts (B) with a Torx-20 driver.

2. Position handle over mounting posts.

3. Tighten set screws (A) with a 3/32" Allen wrench.

PANEL INSTALLATION

Tools required: Phillips screwdriver, 1/4” hex driver

• Remove top trim screws and handles.

• Refer to handle removal section.

• Remove dispenser.

• Install panels, top trim, screws, and dispenser.

Refrigerator Door

NOTE: Inside refrigerator door edges are not trimmed. Installed wood panel edges will be exposed and require finishing.

Freezer Door

NOTE: You can create the panels yourself or consult your cabinetmaker. See dimensional drawings for decorator panel inserts. Decorator panels should be a 1/4” (6.3mm) thick.

W10173024 10/07