JENN-AIR® DETAILED PLANNING DIMENSIONS |
1 of 4 |
30" ELECTRIC RADIANT Cooktop
JEC8430BD – 297⁄8" x 41⁄8" x 211⁄2"
PRODUCT DIMENSIONS
A
B
Top VIEW |
|
|
|
|
G H |
|
|
|
I |
J |
K |
C |
D |
|
|
E |
F |
|
|
|
|
|
|
FRONT VIEW |
|
|
|
|
B |
L |
M |
|
N |
Side VIEW
MODEL # |
JEC8430BD |
||
|
|
|
|
|
|
in |
cm |
|
|
|
|
A |
Overall width |
297⁄8 |
76.0 |
B |
Overall depth |
211⁄2 |
54.6 |
C |
Distance to control cover plate |
97⁄8 |
25.0 |
D |
Width of control cover plate |
81⁄8 |
20.5 |
E |
Distance to center of electrical conduit |
105⁄8 |
27.0 |
F |
Width of recessed cooktop |
285⁄8 |
72.8 |
G |
Height of cooking surface |
1⁄4 |
0.6 |
H |
Height with knobs |
11⁄2 |
3.7 |
I |
Height of recessed cooktop |
23⁄4 |
7.0 |
J |
Recessed height including control cover plate |
33⁄4 |
9.5 |
K |
Recessed height including electrical conduit |
41⁄8 |
10.5 |
L |
Depth of control cover plate |
13 |
33.0 |
|
|
|
|
M |
Depth to center of electrical conduit |
2 |
5.0 |
|
|
|
|
N |
Depth of recessed cooktop |
201⁄4 |
51.5 |
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing |
JRC120041A 07/2012 |
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary. |
JENN-AIR® DETAILED PLANNING DIMENSIONS |
2 of 4 |
30" ELECTRIC RADIANT Cooktop
JEC8430BD – 297⁄8" x 41⁄8" x 211⁄2"
OPENING/CLEARANCE DIMENSIONS
A |
D* |
E
B |
|
|
|
|
|
|
|
|
|
|
|
B |
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
F |
|
|
|
|
|||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
e |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
C |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FRONT VIEW
Side
Cabinet
G
H
MODEL # |
JEC8430BD |
|||
|
|
|
|
|
|
|
in |
cm |
|
|
|
|
|
|
A |
Width of combustible area above |
30 |
76.2 |
|
cooking surface (min.) |
||||
|
|
|
||
|
|
|
|
|
B |
Width from cooktop to fixed wall |
0 |
0.0 |
|
or other combustible material (min.) |
||||
|
|
|
||
|
|
|
|
|
C |
Recommended width to outer edge of outlet |
10 |
25.4 |
|
|
|
|
|
|
D* |
Height to bottom of uncovered wood or |
30 |
76.2 |
|
metal cabinet above cooking surface (min.) |
||||
|
|
|
|
|
E |
Height to bottom of uncovered wood |
18 |
45.7 |
|
or metal cabinet (min.) |
||||
|
|
|
||
|
|
|
|
|
F |
Recommended height to top edge of outlet |
12 |
30.5 |
|
|
|
|
|
|
G |
Depth of upper cabinet |
13 |
33.0 |
|
|
|
|
|
|
H |
Depth from cutout to wall (min.) |
3⁄4 |
1.9 |
|
I |
Width of cutout |
291⁄8 |
74.0 |
|
J |
Depth of cutout |
203⁄8 |
51.9 |
|
K |
Depth from cutout to front of countertop |
21⁄8 |
5.4 |
|
e |
Recommended electrical access location |
|
|
|
|
|
|
|
*Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet is covered by not less than 1⁄4" (0.6 cm) flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
If installing a hood or microwave hood combination above the cooktop, follow the hood or microwave hood combination instructions for dimensional clearances above the cooking surface.
ELECTRICAL REQUIREMENTS
240 volt, 60 Hz, 40-amp fused, grounded circuit is required. A dedicated circuit is recommended. 48" (121.9 cm) of 1⁄2" (1.3 cm) I.D. flexible cable is provided.
LOCATION REQUIREMENTS
•To ensure cooktop base clearance, cabinet side walls need to be wider than the cutout.
•If cabinet has a drawer, allow a 41⁄2" (11.4 cm) minimum clearance between countertop and top of drawer.
COOKTOP OVER SINGLE WALL OVEN INSTALLATION REQUIREMENTS
•For approved model number combinations, refer to the under counter label on the bottom of the cooktop burner box.
•To install a cooktop over a single wall oven, refer to page 3.
I H
J
K
Side VIEW |
TOP VIEW – cutout |
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JRC120041A 07/2012