jcb JCB-SCH12Li Safety And Operating Manual

Page 1
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
Safety and operating manual
Battery Charger JCB-SCH12Li
Page 2
Page 3
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Save all warnings and instructions for future reference.
1) Protect the battery charger from rain and moisture. The
penetration of water in a battery charger increases the risk of electric shock.
2) Do not charge batteries of other manufacturers.
Danger of
fire and explosion.
3) Keep the battery charger clean.
Contamination may cause the danger of electric shock.
4) Check the battery charger, cable and plug each time before using. Do not use the battery charger when defects are detected. Do not open the battery charger yourself.
Damaged battery chargers, cables and plugs increase the risk of electric shock.
5) Do not operate the battery charger on easily inflammable surfaces (e.g. paper, textiles, etc.)
or combustible environments.
There is danger of fire due to the heating of the battery charger during charging.
6) When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to
another.
7) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
SAFETY INSTRUCTIONS
ORIGINAL INSTRUCTIONS
Page 4
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
8) Have your battery charger repaired by a qualified repair person using only identical
replacement parts. This will
ensure that the safety of the battery charger is maintained.
Page 5
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
1. Before charging, read the instructions.
2. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
3. After charging, disconnect the battery charger from the supply mains. Then remove the battery pack.
4. Do not charge a leaking battery.
5. Do not use chargers for works other than those for which they are designed.
6. Before charging, ensure your charger is matching the local AC supply.
7. The charging device must be protected from moisture.
8. Do not use the charging device in the open.
9. Do not short out the contacts of battery or charger.
10. Respect the polarity “+/-” when charging.
11. Do not open the unit and keep out of the reach of children.
12. Do not charge the batteries of other manufactures or ill-suited models.
13. Ensure that the connection between the battery charger and battery is correctly positioned and is not obstructed by foreign bodies.
14. Keep battery charger’s slots are free of foreign objects and
protect against dirt and humidity. Store in a dry and frost-free place.
15. When charging batteries, ensure that the battery charger is in a well-ventilated area and away from inflammable materials. Batteries can get hot during charging. Do not overcharge any batteries. Ensure that batteries and chargers are not left unsupervised during charging.
16. Do not recharge non­rechargeable batteries, as they can overheat and break.
17. Longer life and better performance can be obtained if the battery pack is charged when the air temperature is between 18oC and 24oC. Do not charge the battery pack in air temperatures below 4.5oC, or above 40.5oC. This is important as it can prevent serious damage to the battery pack.
WARNING:
1)This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
2)Children should be supervised to ensure that they do not play
with the appliance.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR BATTERY CHARGER
Page 6
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
SYMBOLS
Read the manual
Warning
Indoor use only
Double insulation
WEEE marking
Page 7
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
1. CHARGE INDICATOR LIGHT
2. BATTERY PACK *
3. BATTERY PACK RELEASE BUTTON
4. CHARGER BASE
COMPONENT LIST
1
3
2
4
*
Not all accessories illustrated are included as standard.
Page 8
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
TECHNICAL DATA
Charger voltage 110-240V~50/60Hz
Output voltage 12V
Charging current 500mA
Power input 13W
Charge battery Li-ion
Protection class
/II
Machine weight 0.14Kg
Page 9
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
CHARGING PROCEDURE
NOTE:
Before using the
tool, read the safety and
operating manual carefully.
1. CHARGING YOUR BATTERY PACK
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another battery charger. The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is switched off by means of a protective circuit: The chuck no longer rotates. In a warm environment or after heavy use, the battery pack may become too hot to permit charging. Allow time for the battery to cool down before recharging. When the battery pack is charged for the first time and after prolonged storage, the battery pack will accept a 100% charge after several charge and discharge cycles.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must charge once before use. When you charge the new battery or one which has not been used for long periods of time, it may not reach full charge until after you have discharged it fully in use and recharged it several times.
Page 10
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
3. HOW TO CHARGE YOUR BATTERY PACK (See
1, 2)
Connect the battery charger to the power supply and the green light (1) will illuminate. Slide the battery pack into the charger base to make the connections. The red light (1) will illuminate to show charging has started. After charging approx 3 - 5 hours, the red light will switch to green, indicating the battery is full, and charging is completed.
2
1
1
Page 11
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
PROBLEM SOLUTION
1. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER. WHY?
1) Check if the charger and the battery pack are specifically designed for working together.
2) The battery can be inserted into the charger only in one direction. Turn the battery around until it can be inserted into the slot, the indicator light should be red when the battery is charging.
2. REASONS FOR DIFFERENT CHARGING TIMES
The charging time can be affected by many reasons which are not defects in your product.
1) If the battery pack is only partly discharged it may be re-charged in less than 3 ­5 hours.
2) If the battery pack and ambient temperature are very cold then re-charging may take more hours.
3) If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to cool first to ambient temperature and then recharging can be started.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance. Your tool requires no additional lubrication or maintenance. Never use water or chemical cleaners to clean your tool. Wipe clean with a dry cloth. Always store your tool in a dry place.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check with your local authorities or retailer for recycling advice.
Page 12
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
WARRANTY STATEMENT
Cutting edge construction technology in your hands
In 1945 JCB began producing construction equipment. Today, we build the world’s number one diggers, each one the product of our unswerving focus on innovation, quality and engineering. JCB power tools are built to give you the same world beating standards of performance. The same innovation, to always get the job done better, the same quality, to never let you down, the same engineering heritage and expertise that you can trust 100%. JCB power tools are guaranteed against manufacturing defects for a period of 5 years from the date of purchase. If your JCB power tool becomes defective within this warranty period, we guarantee to:
• Replaceorrepairalldefectiveparts,freeofcharge,or
• Repairproductsfreeofcharge,or
• Replacetheunitwithaneworre-conditionedunit,freeofcharge.
Conditions
Your 5 year guarantee does not cover defects caused by or resulting from:
• overload,misuse,orneglect
• normalwearandtear,includingaccessorywear
• tradeorhireuse
• repairsattemptedbyanyoneotherthananauthorisedagent
• damagecausedbyforeignobjects,substancesoraccidents
Your 5 year guarantee does not cover:
• batterypacksastheyareguaranteedfora12monthperiod
• accessoriessuppliedwiththepowertool.
Warranty claims
For guarantee claims, please contact JCB Customer Services. You will be required to submit proof of purchase.
JCB CUSTOMER HELPLINE 0845 600 5526
Terms
This guarantee does not affect your statutory rights. JCB SO53 3LE (Registered in England under No. 973387).
Page 13
JCB, SO53 3LE www.JCBDIY.com Customer Helpline 0845 6005526
EC DECLARATION OF CONFORMITY
We,
Positec Power Tools RG24 8AL, UK
Declare that the product
Description
JCB Battery Charger
Type
(JCB-SCH12Li)
Complies with the following Directives,
EC Low Voltage Directive
2006/95/EC
EC Electromagnetic Compatibility Directive
2004/108/EC
RoHS Directive
2011/65/EU
Standards conform to
EN 60335-1
EN 60335-2-29
EN 55014-1
EN 55014-2 EN 61000-3-2 EN 61000-3-3
EN 62233
The person authorised to compile the technical file,
Name: Russell Nicholson
Address Positec Powertools(Europe) LTD
Pinewood, Chineham Business Park,
Basingstoke, Hampshire, RG24 8AL, United Kingdom
2013/04/09
Leo Yue
Quality Manager POSITEC
Page 14
Page 15
Page 16
Loading...