Product Tour
Front
Button panel
Top
Bluetooth paring
Link 20
Back
Microphones
Volume down/up
Lights when active
Press to start your request
Press to stop audio,
timers, alarms, and
responses
Wi-Fi status indicator
Micro USB cable
Battery level indicator
Power on/off
Mic mute/unmute
USB adapter
For more product information, please visit jbl.com
USB connector
for charging
Restart
IPX 7 WaterproofGet Started
1.
Press to power on
2.
Download and run the Google Home app on a phone or tablet.
Set up your JBL Link 20 in the Google Home app.
JBL Link 20 is IPX7 waterproof.
IPX7 waterproof is defined as the speaker can be immersed in
water up to 1m for up to 30 minutes.
IMPORTANT: To ensure that the JBL Link 20 is waterproof, please
remove all cable connections and tightly close the cap; exposing
the JBL Link 20 to liquids without doing so may result in
permanent damage to the speaker. And do not expose JBL Link
20 to water while charging, as doing so may result in permanent
damage to the speaker or power source.
Specication
• Transducer: 2 x 50mm
• Output power: 2 x 10W
• Frequency response: 65Hz-20kHz
• Signal-to-noise ratio: >80dB
• Battery type: Lithium-ion Polymer (3.7V, 6000mAh)
• Battery charge time: 4.5 hours @5V 2.3A
• Music play time: up to 8 hours (varies by volume level and
content)
Wireless network: 802.11b/g/n/ac (2.4/5GHz)
•
• Bluetooth version: 4.1
• Supported audio formats: HE-AAC, LC-AAC, MP3, Vorbis,
WAV (LPCM), FLAC, Opus
• Dimensions (Dia x H): 93 x 210 mm
• Weight: 913g
The Wi-Fi CERTIFIED Logo is a certification mark of the Wi-Fi
Alliance. The Wi-Fi Protected Setup Identifier Mark is a mark of the
Wi-Fi Alliance.
®
The Bluetooth
word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
HARMAN International Industries, Incorporated is under license.
Other trademarks and trade names are those of their respective
owners.
Chromecast is a trademark of Google Inc. Google Play, and the
Google Play logo are trademarks of Google Inc.
This equipment complies with FCC/IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment. This eqipment
should be installed and operated with minimum distance 20cm
between the radiator & your body.
ce matériel est conforme aux limites de dose d'exposition aux
rayonnements, fac / ic rss-102 énoncée dans un autre
environnement.cette eqipment devrait être installé et exploité avec
distance minimale de 20 entre le radiateur et votre corps.
TR03993_C
For Wi-Fi 5G device
FCC Caution:
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with and/or damage this
device. No configuration controls are provided for this wireless equipment allowing any
change in the frequency of operations outside the FCC grant of authorization for US
operation according to Part 15.407 of the FCC rules.
IC Caution:
User should also be advised that:
(i) The device for operation in the band 5150 - 5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems; (ii) the
maximum antenna gain permitted for devices in the bands 5250 - 5350 MHz and 5470 5725 MHz shall comply with the e.i.r.p. limit: and
(iii) The maximum antenna gain permitted for devices in the band 5725 - 5825 MHz
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point
operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users
(i.e. priority users) of the bands 5250 - 5350 MHz and 5650 - 5850 MHz and that these
radars could cause interference and/or damage to LE-LAN devices.
Exposure of humans to RF fields (RSS-102)
The computers employ low gain integral antennas that do not emit RF field in excess of
Health Canada limits for the general population; consult Safety Code 6, obtainable from
Health Canada’s Web site at http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wireless adapters conforms to the
IC limit of the RF exposure requirement regarding IC RSS-102, Issue 5 clause 4. SAR tests are
conducted using recommended operating positions accepted by the FCC/ RSS with the
device transmitting at its highest certified power level in all tested frequency band without
distance attaching away from the body. Non-compliance with the above restrictions may
result in violation of FCC RF exposure guidelines.
Use Restriction Attention in France, operation is limited to indoor use within the band
5150-5350 MHz.