Jaypro Sports FNFB-40 User Manual

FNFB-40

(40 FT FIELDPRO FOOTBALL BACKSTOP SYSTEM)

Installation Instructions

Call Jaypro Sports Equipment at 1-800-243-0533

during regular business hours for technical support.

www.jaypro.com

Rev: - Page 1 of 8

JAYPRO SPORTS

P A R T S L I S T

ITEM #

QTY

DESCRIPTION

1

2

26 FT FIELD NET POLE (LOWER POLE HALF)

2

2

22 FT (UPPER POLE HALF)

3

2

GROUND SLEEVE WELDMENT / END CAP

4

2

5/16 - #10 POLYESTER BLACK BRAIDED HOISTING ROPE x 85
FT 5 2

6 5/8 ID BLACK CAP

6

4

3/8"-16 x 7-3/8" LONG EYEBOLT STAINLESS STEEL

7

4

3/8"-16 HEX HD LOCK NUT, SS

8

8

3/8" FLAT WASHER, SS

9

2

3/8’’ QUICK-LINK SS

10

2

2’’ SWIVEL PULLEY

11

16

5/16” x 3 1/8” SNAP HOOK, ZP

12

2

6" LONG GALV. STEEL CLEAT

13

4

1/4"-20 x 8 1/2" HEX HD SCREW

14

4

1/4" FLAT WASHER , SS

15

12

1/4" WASHER LOCK, SS

16

4

1/4"-20 NYLON LOCK NUT, SS

17

4

1/4-20 ACORN NUT SELF-LOCK

18

2

3/16” COATED AIRCRAFT CABLE 50’

19

8

1/4" WIRE ROPE CLIPS

20

4

1/4" WIRE ROPE THIMBLES

21

12

3/16 OD 11/16 RIVET (ALUMINUM)

22

100

8" BLACK CABLE TIE

23

1

3-1/2" x #36 KNOTTED NYLON SQ. MESH, UV TREATED WITH
1/4" ROPE BORDER (BLACK) 40’ H x 40’ W

40 FT FIELDPRO FOOTBALL BACKSTOP SYSTEM

IMPORTANT NOTICE:

1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING

HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.

2) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE HAZARDOUS.

3) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE

HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR REPLACEMENT,
CONTACT YOUR DEALER OR JAYPRO SPORTS.

Rev: - Page 2 of 8

TOOLS REQUIRED:

Concrete, block or crushed stone.

CONCRETE

Note these are suggested dimensions for average
soil conditions, consult local building codes.

STEEL REBAR

40’ BETWEEN POLES

(1) 3/8” Socket Wrench and Box Wrench (1) 7/16” Nut Driver
(1) 9/16” Socket Wrench and Box Wrench (1) Cable Cutters
(1) 3/16 in Rivet Gun

SPECIAL NOTES:

 Spacing between poles is 40 ft.
 Net should be removed and stored after the season is over.
 Net should be removed prior to a major storm or high winds.

Layout & Excavation:
Clear working area from obstructions. Determine the proper location for the poles on the
field. (See Figure 2)

Install Sleeves:
Dig footing hole using the dimensions shown in Figure 1. Pack bottom of footing hole
with 12” of gravel or concrete block or pour 12-1/4 inch concrete pad and allow concrete
pad to cure for 48 hours. Install ground sleeve and pour concrete as shown in Figure 1.
While not required, Jaypro recommends using 6 lengths of 5/8 inch rebar, 54 inches long,
wired together into a 24 inch diameter basket and placed around the ground sleeve in the
footer hole. Wait 48 hours before inserting poles. The top of the ground sleeve should be
flush with the finished grade.

Rev: - Page 3 of 8

Figure 1

Figure 2