INSTALLATION INSTRUCTIONS
Pressure Balance Valves
Part #’s: J-CSV, J-PBV, J-DIV-CSV, J-DIV-PBV
Confid ence from start to finish.
FOLLOW ALL APPLICABLE LOCAL PLUMBING CODES, PUBLIC HEALTH AND SAFETY CODES
®
J-CSV J-PBV
J-DIV-CSV
J-DIV-PBV
j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133
10.12.16
JACLO.COM | PG 1
Supplied
Separately
Supplied Separately if used
Figure 1
Hot Stop
Valve
Finished
wall
Lower
cartridge
Upper
Cartridges
(Varies)
PBV
Figure 3
CSV
Trim Ring
Limit stop
Trim Cap
(Trim varies)
Cap
Cold Stop
Valve
Figure 2
UP
H C
DOWN
Figure 4
Lower
Higher
Figure 5 Figure 6
VALVE INSTALLATION
1. Turn off water supply.
2. Install valve in rough wall blocking within min. max. dimensions to nished wall. Figure 1
3. Remove plastic roughing shield.
4. Turn off hot and cold stops. Figure 2
5. Remove trim ring.
6. Remove upper and lower cartridges and store in clean package.
7. Connect hot and cold piping to valve. Figure 4
8. Connect shower and or tub piping to valve. Install pipe plug on any unused port. Figure 4
9. Turn water on.
10. Place a suitable container under valve and turn on hot and cold stops. Run water until it is
clear and free of debris.
11. Turn off hot and cold stops.
12. Clean inner valve body.
13. Reinstall lower and upper cartridges. Installation tip: use a little silicone grease to keep
seals in place during installation.
14. Install trim ring.
15. Open hot and cold stops and check for leaks.
16. Repeat steps 11-13 if leak is found.
17. Reinstall plastic roughing shield.
Faceplate
Longer Screw
Gasket
10.12.16
JACLO.COM | PG 2
j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133