Jaclo 83224, 88224, 85224, 83232, 83236 Installation Manual

INSTALLATION INSTRUCTIONS

JACLO zeroEDGE® and SLIM CHANNEL DRAINS

Part #’s: 88224, 88232, 88236, 88242, 88248, 88260

85224, 85232, 85236, 85242, 85248, 85260 Confidence from start to finish.® 83224, 83232, 83236, 83242, 83248, 83260

zeroEDGE®

GRATE LEGS

SLIM

GRATE LEGS

*

* Adhesive must be compatible with 304 Stainless Steel

INSTALLATION

1.Determine location for channel drain

2.Install subfloor and backer board adhering to local codes

3.Cut hole in floor allowing additional 1/4". Allow access to fit and clamp no hub coupling. See Fig. 1

4.Install no hub coupling onto channel drain

5.Apply a bead of silicone caulking to the underside of tile flange

6.Install channel drain, by attaching no hub coupling to existing piping

7.ANSI A118.10 compliant membrane must be used for this installation. Cut membrane to match opening in channel drain base

8.Install waterproof membrane as per manufacturer’s instructions. Adhere membrane to tile flange on channel drain using membrane manufacturer’s recommended adhesive

9.Apply thin set mortar and install tile

10.Once above is completed and dry, install channel drain grate

11.Install grate in channel drain base. If required, adjust legs on grate level with tile profile. Legs extend clockwise rotation or retract counter clockwise rotation. Adjust all legs to base to distribute grate level evenly on base

jaclo industries | 129 Dermody Street Cranford, NJ 07016	REVISED 9.9.2016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133	JACLO.COM | PG 1