Jaclo 6940-T672-428 User Manual

INSTALLATION INSTRUCTIONS

Roman Tub

Product Number 6940

NOTE: Always provide an access panel for concealed deck plumbing.

1

ROUGH-IN INSTALLATION

1 › Remove trim and top mounting nut from

valve. Check the mounting hole pattern and
hole size information as shown in FIGURE 1.
The 10" dimension may vary according to the
installation.

2 › Slide the deck housing fitting (7) through the

opening in deck. From the underside, slide
washer (8) over fitting (7), and tighten in place
using spout nut (9).

3 › Screw valve nut (15) all the way down on the

valve body. Make sure that the fibre washer
(16) is on top of the nut.

4 › Install hot and cold valve bodies into the

holes in the deck.

5 › Install nut (15) on top of the valve body and

align the valve nut with the top of the valve
body to the dimension shown in FIGURE 2.

6 › Rotate outlet of valve bodies to facilitate the

connection to the deck housing and secure
by tightening the bottom valve nut.

7 › Repeat for the other valve.

8 › Attach both valve outlets to the bottom

deck housing inlet. Follow the local code
requirements.

9 › Attach supplies to the valve inlets (bottom

male thread of valve).

JA CLO.COM

RO MAN TUB | PG 1 REVISED JULY ‘08

j a c l o i n d u s t r i e s | 129 Derm ody S treet Cra nfo rd, N J 070 16
p 908 .653 .44 33 | 80 0.8 5 2.3 906 f 908 .653 .17 17 | 80 0.85 2.4 133

2

JA CLO.COM

RO MAN TUB | PG 2

SPOUT AND HANDLE INSTALLATION

(Handles vary)

1 › Make sure both “O” rings (6) are placed in the grooves of the

shank (these are factory installed - DO NOT REMOVE).

2 › Apply a thin bead of silicone to the underside of the spout and

slip spout into the deck housing fitting.

3 › Face spout in the correct position over the tub and tighten into

place using set screw (5).

4 › Screw adapter (14) into escutcheon (13). New style escutcheons

do not require adapters. Apply a small bead of silicone on the
underside of the escutcheon and install on the valve bodies.

5 › Slide handle onto the valve and tighten in place using set screw

(12).

6 › Remove flow straightener assembly from spout outlet. Turn on

water supplies and check for leaks. Run water through faucet for
sufficient time to flush debris from lines.

7 › Reinstall flow straightener.