Jaclo 1616-DLRC User Manual

INSTALLATION INSTRUCTIONS

Dream Light Rain Canopy

Product Numbers: 1620-DLRC, 1616-DLRC, 1212-DLRC, 16R-DLRC, 12R-DLRC

Please read instructions carefully before beginning the installation.

PARTS

1 › Stainless Steel Showerhead

2 › LED lights

3 › Printed circuit board IP66/IP67

4 › Quick disconnect coupling (with flow switch)

to showerhead

5 › Flow switch

6 › Bipolar connector IP68 for flow switch

7 › Bipolar terminal box IP68 for power supply

8 › 2-pole power cable

9 › 7VDC / 110VAC / 60Hz Transformer

10 › 100 cm hose, 1/2”F x 1/2”F

11 › 4 Expansion bolts for the false ceiling

12 › 4 Screws

13 › Template to easily mark the 4 fixing holes and the break-

through for passage of electric cables and water hose

14 › ½”M x ½”F adapter for the hose (in case your wall has a ½” F

connection)

15 › Allen wrench and screws

16 › Rubber nozzles (spare)

JA CLO.COM

j a c l o i n d u s t r i e s | 129 Derm ody S treet Cra nfo rd, N J 070 16

|

PG 1 REVISED JULY ‘08TH ERMOSTATIC WALL VA LVE

p 908 .653 .44 33 | 80 0.8 5 2.3 906 f 908 .653 .17 17 | 80 0.85 2.4 133

PLUMBING EQUIPMENT

Water line: arrange your shower box with
the water supply line and coupling for the
showerhead. The coupling must be above the
ceiling. (Fig. 1).

20 litres of water per minute is enough for the
Dream Light showerhead to work. In fact, the
showerhead, which is installed parallel to the
floor, supplies a “free falling” stream of water
like soft rain. Make sure that the faucet supplies
at least 25 liters of water per minute. Naturally,
the higher the flow rate of the faucet, the better
the showerhead will work. Also make sure that
the hot water heater supplies enough hot water
for proper functioning.

ELECTRICAL EQUIPMENT

Power connection: arrange your shower
box with the electrical connection for the
showerhead LED lights, placing it above the
false ceiling (Fig. 1). Warning: The electrician
must use a power cable that is two-pole, 1 mm2
size, outside diameter between 5 and 13 mm.

Power source must be externally switched
GFCI circuit and must be installed in
accordance with local and national codes.

The transformer: 7VDC / 110VAC / 60Hz must

be installed outside the shower box in a safe
place (Fig. 1).

Turning the LED lights on: LEDs are devices
that generate monochromatic light. For them to
work properly, they need only a small amount of
power supply and voltage and therefore use little
energy and run on low temperatures the LEDs
are activated when the faucet is turned on, using
the stream of water through the Flow switch (5).

FALSE CEILING

Once the electrical and hydraulic systems are
hooked up, install the false ceiling with suitable
reinforcement, as when mounting a chandelier,
and make sure it is perfectly level.

Keep a distance of at least 12 cm between the
ceiling and the false ceiling (Fig.1). Position the
template, mark with a pencil the 4 attachment
holes and the central beak-through that will
house the electrical and hydraulic parts of the
showerhead (Fig.2).

Make the 4 attachment holes having a 10 mm
diameter.

JA CLO.COM

LU XURY DREAM LI GHT

|

PG 2