Jaclo 12R-LH-101 User Manual

INSTALLATION INSTRUCTIONS

Lumiere Circolare

Please read instructions carefully before beginning the installation.

PARTS

PARTS

Component Parts

1 › Ceiling-mounted shower arm and flange

2 › Screws and expansion bolts

3 › Ceiling Support

4 › Dowels

5 › Connector

6 › Shower head

7 › Cover

8 › Screws for fixing cover

9 › Dichroic lamp 12 V-20 Watt connection

GU 5,3

JA CLO.COM

j a c l o i n d u s t r i e s | 129 Derm ody S treet Cra nfo rd, N J 070 16

|

PG 1 LU MIERE C IRCOLAR E

p 908 .653 .44 33 | 80 0.8 5 2.3 906 f 908 .653 .17 17 | 80 0.85 2.4 133

INSTALLATION INSTRUCTIONS

POWER REQUIREMENTS

1 › Shower requires 1/2” female IPS connection in ceiling

2 › Roughing: Requires open box in ceiling approximately

1” smaller in diameter then top shade support.

Blocking will be required in center for shower arm

flange mounting.

3 › Insert the top shade support centering the hole with

the ceiling arm support flange and mark all the fixture

holes ( Fig. 1 ).

4 › Make holes in the ceiling ( Fig. 2 ) and mount the

expansion bolts ( Fig. 3 ).

5 › Apply Teflon to the threaded end of the 1/2” shower

arm, then screw it onto the water intake and, using

screws 2b, secure the support flange to the ceilling

( Fig. 4 ).

6 › Fix the top shade support (3) to the ceiling using

screws 2b ( Fig. 5 ).

8 › Mount the shower head to the shower arm

using the two set screws. ( Fig. 7 ).

9 › Put the cover on (7) and secure it to the ceiling

support (3) with screws (8). ( Fig. 8 ).

110 VAC 2AMP GFI branch circuit

Note: GFI outlet must be installed in

accesible location.

ELECTRICAL EQUIPMENT

Power connection: arrange your shower box with the
electrical connection for the showerhead LED lights,
placing it above the false ceiling (Fig. 1). Warning: The
electrician must use a power cable that is two-pole, 1
mm2 size, outside diameter between 5 and 13 mm.

Power source must be externally switched
GFCI circuit and must be installed in accordance
with local and national codes.

The transformer: 7VDC / 110VAC / 60Hz must be

installed outside the shower box in a safe place (Fig. 1).

Turning the LED lights on: LEDs are devices that
generate monochromatic light. For them to work
properly, they need only a small amount of power
supply and voltage and therefore use little energy and
run on low temperatures

JA CLO.COM

|

PG 2

LU MIERE C IRCOLAR E