Jackson Scaltrol User Manual

The Scaltrol (item 1) ships with the check valve (item 5). All of the

installation. Installations must com

-

ply with all applicable regulatory, health and building codes. It is the respon

-

sibility of the installer to ensure that requirements are met. It is also the

responsibility of the installer to ensure that plumbing is properly supported.

1. The Scaltrol is to be securely mounted to a wall or piece of equipment

using the attached mounting bracket. It must be installed so that the car

-

tidge is pointing towards the floor. The Scaltrol unit will not operate correctly

otherwise. Ensure that whatever the unit is mounted to is able to support the

2. The unit should be mounted with a shut-off valve (as shown with item 2).

3. The check valve should be mounted with the direction arrow pointing

Replace when the level in the cartridge reaches the bottom red end cap. Use the attached wrench to unscrew the cartridge chamber and remove the

cartridge. Once replaced with a new one (contact your chemical specialist regarding replacement parts), screw the cartridge chamber back on and

You may order a replacement cartridge using part number RSC-100. This entire kit (ScalTrol unit, check valve and this instruction sheet) can be

Specifications subject to change without notice

07610-002-18-72B (06/05)

1.888.800.5672

www.jacksonmsc.com

Scaltrol Option

Installation Sheet

Out to dishmachine

Item Description Qty Part Number

Scaltrol mounting
bracket

1 Scaltrol Unit 1 4730-003-05-76
2 3/4” NPT Ball Valve 1 Buy Locally
3 3/4” NPT Close Nipple 3 Buy Locally
4 3/4” NPT Union 1 4730-212-05-00

5

3

2

4

5 3/4” NPT Check Valve 1 Buy Locally

Note:
others items shown are for a suggested

Unit Mounting Instructions:

From system potable
water supply.

weight of the Scaltrol.

This will allow for easy cartidge replacement.

1

away from the Scaltrol.

4. Connect to dishmachine’s incoming plumbing.

WARNING

The Scaltrol should never be installed in direct sunlight or in an area exposed to excessively cold/freezing temperatures!

Cartridge Replacement Instructions:

tighten by hand. DO NOT USE THE SUPPLIED WRENCH TO TIGHTEN THE CARTRIDGE CHAMBER!

ordered using part number 6401-003-05-80.

Specifications:

1. Check valve - 3/4” NPT, brass construction with 3 lbs cracking pressure.

2. Scaltrol, 3/4” NPT inlet and outlet, plastic body with replaceable cartridge.

Jackson MSC Inc., P.O. Box 1060, Barbourville, KY. 40906 [phone]