Jabra 2400 User Manual

Jabra BIZ™ 2400 USB
USER MANUAL
1
© 2011 GN Netcom A/S. All Rights Reserved.
This user guide is published by GN Netcom A/S.
The information in this user guide is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by GN Netcom A/S. GN Netcom A/S assumes no responsibility or liability for any errors or inaccuracies that may appear in this user guide.
Duo anD mono heaDse t
Headband
Speaker
Headset
Clothing clip
2
Speaker
Volume control
Soft button (O)
Answer/end button
Microphone
USB plug
Mute button
Soft button (×)
HEADBAND ASSEMBLY
Headband
Ear cushion
EAR HOOK ASSEMBLY
Ear hook ring
Ear hooks (Small/Large)
Ear gel
NECKBAND ASSEMBLY
CLOTHING C LIP
Neckband
Neckband ring
Name tag
Transparent cover
8
3
how to connec t heaDse t to Pc
Plug the headset directly into a free USB port on your PC. Once connected, the headset's mute and hookswitch buttons will be illuminated.
The rst time connected, your PC displays a small pop-up message in the task bar to indicate that a new device has been found. You are now ready to use the headset.
how to wear the Duo anD mono heaDset
Adjust the headband length.
The headband is adjustable in length to t the size of your head. Push or pull the top section of the headband until the headset ts comfortably.
Wear the headset.
Duo: Position one speaker over each ear with the
band going over the top of your head, just as with a traditional pair of headphones.
Mono: Place the headband over your head, with
the headset positioned against your preferred ear and the T-bar positioned just above the opposite ear. Adjust the headband for optimal t on your head.
Position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less than 2 cm (3/4") from your mouth.
.
2 cm 3/4"
4
How to rotate the boom arm.
The boom is free to rotate 360
How to attach the ear cushion.
Align the ear cushion against the neckband ear plate so that the groove in the ear cushion slips around the ridge of the ear plate. Rotating the cushion will ensure it snaps securely into place (you can remove it as you attach it).
o
wearing the mono heaDset with the heaDbanD
The mono Jabra BIZTM 2400 model include a headband.
How to remove the headband
Remove the ear cushion by gently pulling it o the ear-plate. Push on the inner part with your thumb until the headset clicks out of the headband.
5
Loading...
+ 10 hidden pages