Involight LED SPOT50 User Manual [ru]

LED SPOT50

USER MANUAL V1.0 EN

INTRODUCTION

* LED SPOT50 rated for IP67 to use in any venue including outdoor and underwater
* 36 quality high power LEDs, each LED is 1W, RGB color mixing
* AUTO run when no DMX controlling
* 4 DMX channels
* Stand-alone operation with master/slave

* with auto-switching power unit inside, auto adapts 100V-240V 50/60Hz

OPERATION

AUTO Mode:

This mode allows a single unit to auto change in Auto Mode.

1) Press <MENU> until “Auto” appears on the display, and press <ENTER>.

Master/Slave Mode:

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of
the units. For longer cable runs we suggest a terminator at the last fixture. For more information about
terminators

2) Choose a unit to function as the Master. The unit must be the first unit in line. Press <MENU> until
“Auto” appears on the display, and press <ENTER>. Set A001 for all linking up units as slave units.

DMX Mode

This mode allows the unit to be c ontrolled by any universal DMX controller. If you are unfamiliar with
DMX

1) Press <MENU> until “A***” is displayed and press <ENTER>.

2) Scroll through to select the desired address, and press <ENTER>.

DMX Channel Value

Channel 1 0 Close; 1-127 Strobe speed; 128-255 Brightness
Channel 2 0-255 (R) Brightness of red color
Channel 3 0-255 (G) Brightness of green color
Channel 4 0-255 (B) Brightness of blue color