Involight LED PANEL432 User Manual [ru]

LED Flood Light 432/10RGB

This device is lighting effect which can create decorative effects, it is designed for

professional use, e. g. on stages in disco club, theatres etc

A. SPECIFICATION

432 super bright leds:

Red: 18X8 Green: 18X8 Blue: 18X8

Red: 30000mcd, Green: 30000mcd, Blue: 20000mcd

Led beam angle: 30degree

Projector output distance: 30~35m

2X8 character LCD Display

selectable built-in programs, Auto running, DMX mode , slave mode,

sound-activated.

selectable 5. 8. 14. 26 DMX channel for different applications

Size: 54cm*19cm*7.5cm

Weight; 4.6g

Power in; 100V/240V 60HZ/50HZ

Power consumption; 50W

B. 1,the picture of front side

2, the picture of back side

C. OPERATION;

After opening the power, the LCD display will be as the follows:

1 of 1 pages

Press “MODE”button to activate the main menu: built-in progra m, Auto run, DMX mode,

Slave mode, sound mode.

built-in program-- running one of 14 built-in programs

Auto run—running built-in programs one after another in continuous loop.

DMX mode--controlled by DMX controller

Slave mode—the projectors in this mode will be synchronously run with the projectors in

master mode

Sound mode-- running by sound - activated

1. A program is a sequence of different steps, with LED flood light 432/10RGB yon can select

14 different Progra ms. press“set up”and up/down buttons to select the programs (00-14) and

select the desired program value (step time, flash).

For example,

Press “setup”button to move the cursor to select 02 and the desired Sp (step time)or Fs (flash

speed)

Sp--step time value from 001-100

Fs--flash speed from 00-100

2. Auto run

Running 14 programs in a continuous loop, the frequency means the running times. it can be

set up via the buttons up/down

3. DMX mode

You can control the devices individually via your DMX-controller

1) Addressing

The control Board allows you to assign the DMX address which is defined as the first

channel from which the LED Flood light 432/10RGB will respond the controller. For address

setting, press “set up”buttons until the display shows as follows:

Set the desired address via the up/down buttons

2) DMX-PROTOCOL

2 of 2 pages