Intex CL1110 User Manual
169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25”
(
INTEX®OWNER'S MANUAL
11/18/2011
1
MULTIFUNCTION LED LIGHT 3 AAA Cell Size Batteries Model CL1110
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
WARNING
Adult use only.This product is not a toy, keep away from children.
•
• Do not stare directly at the light emitted by this product.
• This product is resistant to rain and splashing water, but it is not submersible. Do not drop into or
immerse in water.
General Information
• This product operates on three (3) AAA size batteries (not included). LED light wattage: 1 W.
For maximum power use alkaline batteries. Remove batteries from equipment which is not to be used for an extended
•
period of time.
• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium)
batteries.
• Remove used batteries promptly.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• The LED is a lifetime light source. It will never need to be replaced.
• The operating time for this product depends on whether it is run continuously or intermittently. Intermittent use extends the
operating time of a set of batteries.
• Two additional battery housings are provided to hold two sets of three (3) AAA size batteries.
• To clean the product, use only a damp cloth. Avoid strong cleaner, excessive water and abrasive brush.
69
O
P
SAVE THESE INSTRUCTIONS
Page 1
169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25”
(
Functions and Operation
• ON/OFF push button: Sets light brightness in lantern and flashlight mode (see Fig 1 A):
Press Button Brightness Percent Battery Life
Once Low 8% * 28 hours
Twice Medium 50% * 3 hours
Three times High 100% * 1 hours
Four times Off
Fig 1 A
• Function-switch: Selects operating mode via 3-way switch (see Fig. 2B):
Based on 3 AAA fresh alkaline batteries.
*
Switch
Position
SOS
Emergency beacon – international SOS signal light
Function/Operating Mode
69-*PO-R1-1211
1
11/18/2011
169
PO
Fig 2 B
o Lantern/Flashlight mode/OFF
HAZARD Flashing hazard light
Note: The 3-way switch functions take priority over the
ON/OFF push button functions.The brightness of the
flashing hazard light and emergency beacon light are
defaulted to full power (100%) and cannot be adjusted.
SAVE THESE INSTRUCTIONS
Page 2
(
Functions and Operation (Continued)
• Turn-knob: adjust between lantern and flashlight use (See Fig. 2C and 2D):
➢ Turn clockwise to convert light into 360 degree
lantern; can be hung or placed on the table.
Turn counterclockwise to convert light to a flashlight/torch.
➢
mount of turn adjusts the spotlight beam-angle and focus
A
distance. Hanging light in flashlight mode produces a
downward spotlight effect.
169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25”
11/18/2011
69
1
O
P
Fig 2 C
To Install or Replace the Batteries
1.Push the battery housing to side then pull upward to remove it. (see Fig 3).
2. Insert three (3) AAA size batteries following the orientation shown on the battery housing (see Fig 4).
3. Reinstall the battery housing into the product.
Fig 3
SAVE THESE INSTRUCTIONS
Page 3
169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25”
(
Fig 2 D
Fig 4
11/18/2011
Limited Warranty
Your MULTIFUNCTION LED LIGHT has been manufactured using the highest quality materials and workmanship. All Intex products
have been inspected and found free of defects prior to leaving the factory.This Limited Warranty applies only to the MULTIFUNCTION LED
LIGHT.
The provisions of this Limited Warranty apply only to the original purchaser and is not transferable.This Limited Warranty is valid for a period
of one (1) year from the date of the initial retail purchase. Keep your original sales receipt with this manual, as proof of purchase will be
required and must accompany warranty claims or the Limited Warranty is invalid.
If a manufacturing defect is found within this one (1) year period, please contact the appropriate Intex Service Center listed in this manual.
The Service Center will determine the validity of the claim. If the Service Center directs you to return the product, please carefully package
the product and send with shipping and insurance prepaid to the Service Center. Upon receipt of the returned product, the Intex Service
Center will inspect the item and determine the validity of the claim. If the provisions of this warranty cover the item, the item will be repaired or
replaced at no charge.
Any and all disputes regarding the provisions of this Limited Warranty shall be brought before an informal dispute settlement board and
unless and until the provisions of these paragraphs are carried forth, no civil action may be instituted. The methods and procedures of this
settlement board shall be subject to the rules and regulations set forth by the Federal Trade Commission (F.T.C.). IMPLIED WARRANTIES
ARE LIMITED TO THE TERMS OF THIS WARRANTY AND IN NO EVENT SHALL INTEX, THEIR AUTHORIZED AGENTS OR
EMPLOYEES BE LIABLE TO THE BUYER OR ANY OTHER PARTY FOR DIRECT OR CONSEQUENTIAL DAMAGES OR LIABILITIES.
Some states, or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
This Limited Warranty does not apply if the MULTIFUNCTION LED LIGHT is subject to negligence, abnormal use or operation, accident,
improper operation, improper voltage or current contrary to operating instructions, or to damage by circumstances beyond Intex’s control,
including but not limited to, ordinary wear and tear and damage caused by exposure to fire, flood, freezing, rain, or other external
environmental forces. This Limited Warranty applies only to those parts and components sold by Intex. The Limited Warranty does not cover
unauthorized alterations, repairs or disassembly by anyone other than Intex Service Center personnel.
DO NOT GO BACKTO THE PLACE OF PURCHASE FOR RETURN OR REPLACEMENT. IF YOU ARE MISSING PARTS OR NEED
ASSISTANCE, PLEASE CALL US TOLL-FREE (FOR U.S. AND CANADIAN RESIDENTS): 1-800-234-6839.
Proof of Purchase must accompany all returns or the warranty claim will be invalid.
169
PO
SAVE THESE INSTRUCTIONS
Page 4
Loading...