Intermec EasyCoder 201II, EasyCoder 401, EasyCoder 501 SA, EasyCoder 501E, EasyCoder 501S Technical Manual

...
Intermec
External Keyboard
P/N 1-960330-02 Edition 3 September 1998
Technical Manual
1
GENERAL INFORMATION
Intermec External Keyboard Technical Manual Edition 3, September 1998 Part No. 1-960330-02
Application of Use
The External Keyboard (part number 1-200591-01) is an RS 232C keyboard intended for connection to the entire range of Intermec Fingerprint-compatible EasyCoder printers:
EasyCoder 201 IIS, E, SA EasyCoder 401, 401 LL EasyCoder 501S, E, SA, XP EasyCoder 601S, E, XP
The keyboard uses the following communication parameters:
Interface: RS 232C Baud rate: 9600 Parity: None Character length: 8
Stop bits: 2
The keyboard's communication cable is fitted with a female DB25 connector wired as follows:
Pin 1: Not used Pin 2: RXD in Pin 3: TXD out Pin 4–6: Not used Pin 7: Signal ground Pin 8–15: Not used Pin 16: + 5V
(must be enabled by a strap in the printer, see below)
Pin 17-25: Not used
Note that the keyboard requires +5V from the printer, which in some cases must be enabled by a strap on the CPU-board or interface board, see the Technical Manual or Installation & Opera­tion manual for the printer model in question.
Communication
Information in this manual is subject to change without prior notice and does not represent a commitment on the part of Intermec Printer AB.
© Copyright Intermec PTC AB, 1998. All rights reserved. Pub­lished in Sweden.
EasyCoder and Fingerprint are registered trademarks of Intermec Technologies Corp.
2
KEYBOARD MAPPING
Unshifted
Shift key
The Intermec External Keyboard is a standard computer keyboard, which has been converted to produce characters according to Intermec Fingerprint specifications. Therefore, some keys are disabled, whereas others are engraved with misleading designa­tions. Below, you will find illustrations of the keyboard, where the decimal ASCII characters produced by the various keys or key combinations are specified.
For information on how to use the keyboard in connection with an EasyCoder 201 IISA or 501 SA printer, please refer to the manual “Intermec Stand Alone Concept; Operating Instructions”.
Num Lock
Caps Lock
Scroll Lock
27 14 18 20 19
189 49 50 51 52 53 54 55 56 57 48 43 39 39 8 47 42 45928
24 113 119 101 114 116 121 117 105 111 112 125 94
13
55 56 57127 29
97 115 100 102 103 104 106 107 108 124 123 52 53 54
43
60 122 120 99 118 98 110 109 44 46 45 49 50 51
13
23
32 48 4610 22 11
21 6 7 24 25 17 26 12 16 15
Num Lock
Caps Lock
Scroll Lock
27 14 18 20 19
248 33 34 35 36 37 38 47 40 41 61 63 96 42 8 47 4530 28
24 81 87 69 82 84 89 85 73 79 80 93 126
13
31 29
65 83 68 70 71 72 74 75 76 92 91
43
62 90 88 67 86 66 78 77 59 58 95
25
23
32 10 22 11
21 6 7 24 25 17 26 12 16 1
Loading...
+ 6 hidden pages