Intermatic T7802B Owner's Manual

MODEL: T7802B

SEVEN-DAY DIAL TIME SWITCH

4 POLE; Two Normally Open - Two Normally Closed

MINIMUM “ON” TIME 3-1/2 HR. UP TO 3-1/2 DAILY ON-OFF OPERATION

40 AMP. RESISTIVE EACH POLE 120V -480V AC.

40 AMP. INDUCTIVE, TUNGSTEN EACH POLE 120V, 208V, 240V, OR

277V AC. 1000 VA PILOT DUTY EACH POLE 120V - 277V AC.

24 FLA, 144 LRA (2 HP) - 120V AC.; 28 FLA, 168 LRA (5 HP) - 240V AC.

CLOCK MOTOR: 208-277 VOLTS - 60 HZ.

FOR REPLACEMENT MOTOR, ORDER WG1603

CONTACT RATINGS:

208
277V
60 HZ

SUPPLY

LR3730

CLOCK

MOTOR

TO
LOADS

GROUND

WIRING DIAGRAM

SCREW

WIRING INSTRUCTIONS

This Time Switch can be wired to control one to four circuits simultaneously on a seven day schedule. Clock
motor voltage may be other than load voltage, but must be as specified. For terminal markings, internal wir­ing and contact arrangements refer to wiring diagram above. To form the common poles of a DOUBLE POLE
DOUBLE THROW switch, if required, install jumpers (extend supply wires) between terminals 1-6 and 3-8.
Use solid or stranded COPPER wire with insulation to suit installation. See table for gauge selection. To make
power connections remove 1/2 inch of insulation from wire ends. Insert bare ends of wire under the pres­sure plate of terminals. Use 3/16 or larger screw driver to tighten terminal screws firmly. REPLACE FRONT

INSULATOR BEFORE TURNING ON ELECTRICITY.

MINIMUM

COPPER

WIRE SIZE

(AWG)

14
12
10

8

MAX.
LOAD

(AMP)

15
20
30
40

MIN.

INSUL-

ATION

TEMP(°C)

60
60
60
75

75°C INSULATION MAX. MOTOR

240 V.

2

2 1/2

3
5

LOAD (HP)

SINGLE PHASE

120 V.

1/2

1
2

-

208 V.

N/A

3 PHASE

240 V.

N/A

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE
INSULATION CLEARS
PRESSURE PLATE

PROGRAMMING INSTRUCTIONS

1. TO SET “ON” TIMES, place bright ON trippers against edge of CLOCK-DIAL at day-of-week and time­ of-day when “ON” operations are desired. Tighten tripper screws securely.

2. TO SET “OFF” TIMES, place dark OFF trippers against edge of CLOCK-DIAL at times when “OFF”
operations are desired. Tighten tripper screws securely.

3. TO SKIP DAYS, omit trippers for the day(s) automatic operations is/are not required.

4. TO SET DIAL TO TIME-OF-DAY, turn dial CLOCKWISE and align the exact day-of-week and time-of-day
(AM or PM) on dial with the TIME POINTER. Some allowance may be required to compensate for gear backlash.

CAUTION: DO NOT MOVE POINTER OR FORCE DIAL COUNTERCLOCKWISE.

OPERATING INSTRUCTIONS

• TOOPERATESWITCHMANUALLY: Move MANUAL LEVER below CLOCK-DIAL left or right as

indicated by arrows. This will not affect next automatic operation.

• IN CASE OF POWER FAILURE OR TO ADVANCE/RETARD TIME: Reset time-of-day, see step 4 of programming instructions.

DISCONNECT ELECTRICITY BEFORE ANY BEHIND-THE-INSULATOR WORK.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

154--01172