Interlogix TX-4012-01-2 User Manual

Installation Instructions

Introduction

This is the GE DesignLine 2-Button Keyfob Installation Instruc­tions for model TX-4012-01-2. The keyfob enables you to turn
the system on before exiting and off before entering the home or to turn on the siren and call the ce ntral monitoring station if there is an emergency.
The keyfob is a lithium coin battery-powered, wireless keyfob designed to fit on a keychain, in a pocket, or in a purse. It provides a convenient option for the following system operations:
• Arm the system (doors, windows, and motion sensors).
• Arm the system with no entry delay (if programmed).
• Disarm the system.
• Trigger panic alarms.

Programming guidelines

Refer to your control panel documentation for instructions on programming and sensor testing your keyfob. Use the following guidelines to add keyfobs to the system:
• Program (learn) the keyfobs into the control panel as unsu­pervised sensors.
• Each learned keyfob uses one of the available zones.
• Use sensor group number 01, 03, 06, or 07 (all Concord, Simon 3, and Simon XT panels only).

Keyfob operation

The keyfob buttons (Figure 1) should operate as follows:
Unlock button. Disarms the control panel. The doors, windows, and motion sensors are disarmed.
Lock button. The following key presses will depend on your control panel configuration.
• If pressed once, the control panel arms doors and windows (stay mode).
• If pressed twice, the control panel arms motion sensors, doors, and windows (away mode) (all Concord, Simon 3, and Simon XT panels only).
• If pressed three times, the control panel activates the latchkey feature if programmed (all Concord, Simon 3, and Simon XT panels only).
Lock and Unlock buttons. If the keyfob is programmed (learned) as a panic or portable auxiliary group number, when you press the Lock and Unlock buttons simulta­neously, th e keyfob will activa te alarm reports to the central station. Depending on the group number, it may activate an audible or silent alarm.
DesignLine 2-Button Keyfob
466-2294A • November 2007
Copyright © 2007, GE Security Inc.

Figure 1. Keyfob buttons

LED
Unlock buttonLock button

FCC compliance

This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC ID: B4Z-RF4004-01-2 Industry Canada ID: 1175C-RF400401

Specifications

Battery Panasonic CR2025 3 VDC, 165 mAh, lithium
Transmitter frequency 319.508 MHz (crystal controlled) Transmitter frequency tolerance ± 8 kHz Transmitter bandwidth 24 kHz Modulation type Amplitude shift key (ASK) Unique ID codes 16 million Peak field strength Typical 40,000 uV/m at 3m Operating temperature 32 to 120°F (0 to 49°C) Enclosure ABS PA-765 Weight 0.50 oz. (14 g) Dimensions (WxHxD) 1.25 x 2.23 x 0.42 in. (3.18 x 5.66 x 1.07 cm) Color Black
coin battery (5-year typical battery life)
Toll-free: 888.GESECURity (888.437.3287 in the US, including Alaska and Hawaii; Puerto Rico; Canada).
Outside the toll-free area: Contact your local dealer.
Technical support
www.gesecurity.com
Loading...