Interlogix TVD-M3245E-2M-P User Manual

TruVision Outdoor IP Camera Installation Manual

P/N 1072624B-EN • REV 1.0 • ISS 30MAY13

Trademarks and

Manufacturer

Certification

FCC compliance

ACMA compliance

European Union

directives

Contact information

The Product Name and logo are trademarks of United Technologies.

Other trade names used in this document may be trademarks or registered

patents

trademarks of the manufacturers or vendors of the respective products.

UTC Fire & Security Americas Corporation, Inc. 2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, USA

Authorized EU manufacturing representative: UTC Fire & Security B.V. Kelvinstraat 7, 6003 DH Weert, The Netherlands

N4131

Class B: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Notice! This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

This Class A digital apparatus complies with Canadian ICES-003.

Canada

Cet appareil numérique de la classe A est conforme à la norme NMB-0330 du Canada.

12004/108/EC (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC.

2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.

For contact information, see www.interlogix.com or www.utcfssecurityproducts.eu.

Content

Introduction 3

Product overview 3 Features 4

Installation 4

Installation environment 4 Package contents 5 Cable requirements 5 Camera description 6 Setting up the camera 7 Connecting the devices 8 Accessing the SD card 9 Mounting the dome camera 9 Mounting the bullet camera 13 Mounting a TVD-CB5 to a dome camera 13 Using the camera with an Interlogix NVR or Hybrid DVR or another system 16 Using the camera with TruVision Navigator 16

Specifications 16

TruVision outdoor IP dome cameras 16 TruVision outdoor IP bullet cameras 17

Pin definitions 18

Introduction

Product overview

This is the user manual for TruVision Outdoor IP camera models:

 TVC-N225E-2M-N(-P) (IP bullet camera)

 TVC-M1245E-2M-N(-P) (1.3MPX WDR bullet camera)

 TVC-M3245E-2M-N(-P) (3MPX WDR bullet camera)

 TVC-M5225E-3M-N(-P) (5MPX bullet camera)

 TVD-N225E-2M-N(-P) (IP dome camera)

 TVD-M1245E-2M-N(-P) (1.3MPX WDR dome camera)

 TVD-M3245E-2M-N(-P) (3MPX WDR dome camera)

 TVD-M5225E-3M-N(-P) (5MPX dome camera)

Installation Manual 3 EN

Features

This section describes the camera features.

 Supports TCP/IP, HTTP, DHCP, DNS, DDNS, RTP/RTSP, PPPoE, SMTP,

NTP, UPnP, ICMP, IGMP, SNMP, FTP, 802.1x, QoS, HTTPS protocols

 Programming and setup through a browser interface

 Live viewing over the network

 50/60 Hz selectable flicker control

 120dB Wide Dynamic Range (WDR models only)

 Motorized lens with zoom function

 Auto focus

 Supports remote upgrades and maintenance

 H.264 video compression with dual capability

 Supports HD (5MPX, 3MPX and 1.3MPX models), VGA,

 IP66 weather proof

 Micro SD card for local storage (dome cameras only)

 Designed to ONVIF and PSIA open standards

Installation

This chapter provides information on how to install the cameras.

Installation environment

When installing your product, consider these factors:

• Electrical: Install electrical wiring carefully. It should be done by qualified service personnel. Always use a proper PoE switch or a 12 VDC UL listed Class 2 or CE certified power supply to power the bullet camera, and a proper PoE / PoE+ switch, a 24 VAC UL listed Class 2, or CE certified power supply to power the camera. Do not overload the power cord or adapter.

• Ventilation: Ensure that the location planned for the installation of the camera is well ventilated.

• Temperature: Do not operate the camera beyond the specified temperature, humidity or power source ratings. The operating temperature of the camera is between -10 to +60°C (14 to 140°F). Humidity is below 90%.

EN 4 Installation Manual

• Moisture: Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately if the camera is wet and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock.

• Servicing: Do not attempt to service this camera yourself. Any attempt to dismantle or remove the covers from this product will invalidate the warranty and may also result in serious injury. Refer all servicing to qualified service personnel.

• Cleaning: Do not touch the sensor modules with fingers. If cleaning is necessary, use a clean cloth with some ethanol and wipe the camera gently. If the camera will not be used for an extended period of time, put on the lens cap to protect the sensors from dirt.

Package contents

Check the package and contents for visible damage. If any components are damaged or missing, do not attempt to use the unit; contact the supplier immediately. If the unit is returned, it must be shipped back in its original packaging.

Package contents:

 Camera

 Hex wrench

 Installation manual

 CD with Configuration Manual and TruVision Device Finder

CAUTION: Use direct plug-in UL listed power supplies marked Class 2/CE certified or LPS (limited power source) of the required output rating as listed on the unit.

Cable requirements

For proper operation, adhere to the following cable and power requirements for the cameras. Category 5 cabling or better is recommended. All network cabling must be installed according to applicable codes and regulations.

Table 1 below lists the requirements for the cables that connect to the camera.

Table 1: Recommended power cable requirements

Bullet camera: 12 VDC power jack or PoE (802.3af)

Dome camera: 24 VAC power jack or High PoE (802.3at)

Installation Manual 5 EN

Camera description

Figure 1: Outdoor IP dome camera

1. Video output interface

2. LINK LED: The yellow LED is lit when the network is connected.

3. ACT LED: The blue LED blinks when the network is correctly functioning.

4. PWR LED: The red LED is lit when the camera is powered up.

5. Micro SD card slot

6. Reset switch.

EN 6 Installation Manual

+ 14 hidden pages