Interlogix AdvisorOne Bluetooth Installation Sheet

AdvisorOne Bluetooth® Installation Sheet

EN

CNF

ES

PR

1. Bluetooth Module

2. AdvisorOne Panel (With Covers Installed)

3. AdvisorOne Panel (With Covers Removed)

English: Installation Sheet

Description

The Advisor™One self-contained lifestyle management and security system detects situations and provides control and information
to home and small business owners (P/N AVO-1037).

This document provides instructions on installing and programming the AdvisorOne Bluetooth module (P/N AVO-BT) for use with
the AdvisorOne panel.

The AdvisorOne Bluetooth module extends the capability of interfacing with the AdvisorOne system to support mobile device
access and control.

Preparation and Installation

Preparing to Install the Bluetooth Module

WARNING: Use caution when installing or removing the power supply to an outlet with a metal cover.

1. Depending on the situation, it may be necessary to contact the central monitoring station before starting the installation.

2. If a power supply is present, remove the screw from the securement tab and unplug the power supply.

3. Remove the screw securing the panel chassis. Open the panel by pressing down on the tabs and carefully swing the panel
chassis open.

P/N 466-4407 • REV C • 23APR15 1 / 4

CAUTION: Use static electricity precautions when handling electronic components.

Installation

Action

Note

US

Plug the power supply into the outlet and secure with the supplied screw.

Canada

Plug the power supply into the outlet.

Do not use the securement tab and screw.

All Other Installations

Follow regional requirements.

4. Disconnect the battery from the battery connector (E in Figure 2) by pressing down on the wire end of the battery clip.

5. Remove the Communication Modules Cover by pulling outward on the tabs (F in Figure 2) and then lifting upward when tabs
release.

6. To access the location of the Bluetooth module, remove the System Electronics Cover (this is the cover with a printed wiring
diagram) by pulling outward on the tabs (C in Figure 2), then disengaging the latch (D in Figure 2) with a small screwdriver and
lifting the cover upward when the latch releases.

Installing the Bluetooth Module

1. Install the Bluetooth module (A in Figures 1 and 3) into the Bluetooth module location (with the bar code label side up).

Carefully align the header of the module (B in Figures 1 and 3) with the pins on the main circuit board. Press into place.
Note: The Bluetooth module must be installed on the main board in the Bluetooth module location (A in Figure 3); it cannot be

installed in any other module location. DO NOT force the module into place.

2. Reinstall the System Electronics Cover, making sure the tabs (C in Figure 2) and the latch (D in Figure 2) are engaged.

3 Reinstall the Communication Modules Cover by pressing the cover down until the tabs (F in Figure 2) snap into place.
Note: All three internal covers must be secured for proper operation.

4. Supply power to the panel as noted in Table 2.

Table 2: Powering the Panel

Note: Connect the battery within 15 seconds of providing AC power to reduce the potential for a low battery indication.

5. Connect the battery to the battery connector on the panel (E in Figure 2). Note: The cable connector locks into place.

6 Close the panel, making sure all tabs are engaged. Replace the screw securing the panel chassis.

7. If the central monitoring station was notified, inform them this operation is complete.

Module Configuration and Programming

Module Configuration – Bluetooth Capability

No module configuration is required (i.e. no visibility timeout, pairing options etc.).

Programming

The Bluetooth capability of the module can be programmed to support key fob-like capability on a mobile device (Smartphone).
Note: The AdvisorSync Mobile software must be loaded onto the mobile device. For more information regarding loading
AdvisorSync Mobile, refer to the AdvisorSync Mobile Remote Installation Sheet (P/N 466-4424).

For more information on how to program the Bluetooth capability to work with AdvisorSync for Mobile Devices, refer to the
AdvisorOne Panel Install & Programming Manual (P/N 466-4405).

2 / 4 AdvisorOne Bluetooth Module Installation Sheet