Interlogix 36X, UVP 1.3 MPX HD 18X Quick Start Manual

UltraView IP PTZ 36X
Camera Quick Start
Guide

P/N 1071694D-EN • ISS 07DEC12

Copyright

© 2012

UTC Fire & Security Americas

Corporation, Inc.
Interlogix is part of UTC Climate Controls &

Security, a unit of United Technologies
Corporation. All rights reserved.

Contact

information

www.interlogix.com

or

www.utcfssecurityproducts.eu

UltraView IP PTZ 36X camera 1 EN

Content

Introduction 1

Before you begin 1

Installation environment 1

Camera description 2

Installing a camera 2

Accessing the camera over the internet 4

Web browser interface 5

Configuring the camera over the internet 5

Specifications 7

Introduction

This pocket guide provides basic information on setting up and using
the UltraView IP PTZ 36X camera. Detailed information on the
cameras can be found in the user manual.

Before you begin

Unpack everything. Check the items for damage, and verify that all
items are included. The camera is shipped with the following items:

 Dome camera

 User manual

 Quick Start Guide

Installation environment

When installing your camera, consider these factors:

• Place the camera in a secure location.

• Ensure that the camera is in a well-ventilated area.

• Do not expose the camera to rain or moisture.

EN 2 UltraView IP PTZ 36X camera

Camera description

Figure 1: Overview of the dome camera (pendant-mount shown)

1. Ethernet RJ45 connector.
Connect to the network
devices.

2. Video output.
Connect the BNC
connector to a CCTV
monitor.

3. Power supply cord.
Connect +24 VAC power
supply.

4. Housing.

5. PTZ module.

6. Bubble.

Installing a camera

1. Prepare the mounting surface and install the camera bracket.

2. Unscrew the bubble from the camera and remove the protective
tape from the PTZ module.

3. Press the two tabs on either side of the PTZ module and remove it
from the camera housing. Ensure the module cables still exit from
the cable entry hole in the top of the housing.

Note: If alarm and audio input/output relays are to be used,
connect them to the PCB of the module and route their cables
through the cable entry hole on tom of the housing. See the user
manual for further information on the alarm connections.

4. Install the housing.

Pendant-mount camera:

Attach the camera housing to the bracket using the screws
enclosed with the bracket.

Flush mount camera:

Adjust the height of the two housing tabs by turning the screw on
which they are attached. The distance (h) of the tabs from the
housing ring must be greater than the thickness of the ceiling.