1
Electronic Emission Notices
Federal Communications Commission (FCC) Statement (005928)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions contained in this manual, may cause harmful interference to radio and television communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-REORIENT OR RELOCATE THE RECEIVING ANTENNA
-INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND THE RECEIVER
-CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT OF THE RECEIVER
-CONSULT THE DEALER OR AN EXPERIENCED AUDIO/TELEVISION TECHNICIAN
NOTE: Connecting this device to peripheral devices that do not comply with Class B requirements, or using an unshielded peripheral data cable, could also result in harmful interference to radio or television reception.
The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.
Copyright
This manual is copyrighted with all rights reserved. No portion of this manual may be copied or reproduced by any means.
While every precaution has been taken in the preparation of this manual, no responsibility for errors or omissions is assumed. Neither is any liability assumed for damages resulting from the use of the information contained herein.
Trademarks
All brand names, logos and registered trademarks mentioned are property of their respective owners.
2
Table of Contents
HARDWARE CONFIGURATION .................................................................... |
3 |
Key Features ............................................................................................................... |
3 |
Motherboard Layout .................................................................................................... |
6 |
Jumper Settings ........................................................................................................... |
7 |
CPU Speed Selection ............................................................................................ |
7 |
JP1 - System Bus Frequency(only for 845G/GE/PE/GV) .................................... |
7 |
JP2 - CMOS Clear .................................................................................................. |
7 |
JP5 - Keyboard Power Select .............................................................................. |
7 |
JP6 - On Board AC97 Codec Sound .................................................................... |
7 |
JP7 - On Board LAN (optional) ............................................................................. |
7 |
Pin Assignment ..................................................................................................... |
8 |
HARDWARE SETUP ...................................................................................... |
9 |
To Install DDR DIMMs ................................................................................................... |
9 |
Installing a New Processor ......................................................................................... |
10 |
To Install a Processor to ZIF Socket ........................................................................... |
10 |
Connect the Processor Fan Connector ...................................................................... |
10 |
Setting the Processor Speed ...................................................................................... |
10 |
BIOS SETUP .................................................................................................. |
11 |
Starting Setup .............................................................................................................. |
11 |
Main Menu .................................................................................................................... |
12 |
Standard CMOS Features ........................................................................................... |
13 |
Advanced BIOS Features ........................................................................................... |
14 |
Advanced Chipset Features ....................................................................................... |
14 |
Integrated Peripherals ................................................................................................. |
14 |
Power Management Setup .......................................................................................... |
14 |
PNP/PCI Configurations ................................................................................................ |
14 |
PC Health Status .......................................................................................................... |
14 |
Frequency/Voltage Control ......................................................................................... |
14 |
Set Supervisor/User Password .................................................................................. |
15 |
Flash Update Procedure ............................................................................................. |
15 |
APPENDIX .................................................................................................... |
16 |
USB 2.0 Driver Installation for Windows 9X ........................................................... |
16 |
Technical Reference Booklet
3
HARDWARE CONFIGURATION
Key Features :
Chipset
•Intel® 845G/GL/GE/PE/GV Chipset.
Processor
•Supports the Intel® Pentium® 4 processors and the Northwood processors in the 478-pin package.
•Supports PSB (Processor System Bus) frequency of 400MHz
(100MHz bus clock).
•Supports PSB (Processor System Bus) frequency of 533MHz
(133MHz bus clock) (only for 845G,845GE,845PE,845GV).
VRM 9.0 (Voltage Regulator Modules) on Board
•Flexible motherboard design with on board VRM 9.0, easy to upgrade with future Intel® Pentium® 4 and Northwood processors.
Cache
•The Intel® Pentium® 4 and Northwood processors built-in L2 Cache.
System Memory
•Up to 2.0 Gbytes of 200MHz or 266MHz DDR SDRAM.
•Supports up to two DDR DIMMs, single-sided or double-sided.
•Supports DDR200/266 unregistered, 184-pin non-ECC DDR SDRAM DIMMs.
•Does not support double-sided x16 DDR DIMMs.
•Up to 2.0 Gbytes of 333MHz DDR SDRAM (only for 845GE/PE/GV).
Note: Please ensure that your DIMMs can meet the specification of SPD.
AGP Controller (only for 845G/845GE/845PE)
•Supports AGP2.0 including 1x/2x/4x AGP data transfers and 2x/4x Fast Write protocol.
•AGP 1.5V connector support only, No support for 3.3V or Universal AGP connectors.
•High priority access support.
•Delayed transaction support for AGP reads that cannot be serviced immediately.
On-board I/O
•On board two PCI fast IDE ports supporting up to 4 ATA, ATA2 , Ultra ATA33/ 66/100 IDE HDDs, CD-ROMs, ZIP drives and LS-120 drives as boot drive.
•One ECP/EPP parallel port.
•Two 16550 Compatible UART serial ports.
•One floppy port supports two FDD of 360KB, 720KB, 1.2MB , 1.44MB and 2.88MB capacity.
•PS/2 keyboard connector.
•PS/2 mouse is supported.
•One front panel sound connector.
•Infrared (IrDA) is supported via a header.
Expanded USB Support
•Includes 3 UHCI host controllers,increasing the number of external ports to six.
•Includes 1 EHCI USB2.0 Host Controller that supports all six ports (Bandwidth shared between six ports).
Hardware Configuration
4
On-board VGA (only for 845G/845GE/845GL/845GV)
•Core Frequency of 200MHz.
•3D Setup Render Engine.
•High Quality Texture Engine.
•3D Graphics Rasterization Enhancements.
•Full 2D H/W Acceleration.
•Motion Video Acceleration.
•Up to 1600x1200 in 8 bit Color at 85MHz Refresh.
•H/W Motion Compensation Assistance for S/W MPEG2 Decode.
•Software DVD at 30fps.
•Integrated 24-bit 230MHz RAMDAC.
System BIOS
•PnP, APM, ATAPI and Windows 95/98/2000.
•Full support of ACPI & DMI.
•Auto detects and supports LBA harddisks with capacities over 8.4GB.
•Easy to upgrade BIOS by end-user.
Plug and Play
•Supports Plug and Play specification 1.1.
•Plug and play for DOS, Windows 3.X, Windows 95/98/2000, as well as
Windows XP.
•Fully steerable PCI interrupts.
Power Management
•Supports SMM, APM and ACPI.
•Break switch for instant suspend/resume on system operations.
•Energy star “Green PC” compliant.
•Hardware monitoring circuit is supported, provide voltage, fan speed, etc. monitoring (optional).
•WOL (Wake-On-Lan) Header support.
•External Modem Ring-in Wake-up support.
•Supports suspend-to-RAM(STR)(optional).
On-board AC97 Sound
•Integrated AC97 controller with standard AC97 Codec.
•Direct Sound and Sound Blaster compatible.
•Full-Duplex 16-bit record and play back.
•PnP and APM 1.2 support.
•Win® 95/98/2000/XP, NTdrivers ready.
•Line-in, Line-out, Mic-in and MIDI/Game port.
•Supports ALC650 AC97 Code for six sound channel output (optional).
On-board Realtek RTL8100BL PCI LAN (optional)
•Provides 32-bit performance, PCI bus master capability.
•Full compliance with IEEE 802.3u 100 Base-T specifications and IEEE 802.3X Full Duplex Flow Control.
•Supports 10 Mb/s and 100 Mb/s operation.
•Supports Wake-On-LAN function and remote wake-up.
•Supports ACPI, PCI Power management and PCI VPD.
Technical Reference Booklet
5
Expansion Slots
•1 AGP slot (845GL/GV supports ADD card only,
845G/GE/PE supports ADD card)(optional).
•3 PCI bus master slots - ver. 2.1 compliant.
CAUTION
Static electricity can harm delicate components of the motherboard. To prevent damage caused by static electricity, discharge the static electricity from your body before you touch any of the computers electronic components.
Hardware Configuration
Loading...