Insinkerator Part-Kit-Misc Installation Manual

INSTALLATION INSTRUCTIONS

Commercial

Products Group

INSTALLING DISPOSER LEGS

1. Turn unit upside down.

2. Pry two guide hole plugs (4) from bottom cover
(3).

3. Make sure threaded stud (5) is extended a
minimum of 1 1/8" from tube (6).

4. Insert leg assemblies through lower end frame
guide holes. Insert screw driver into tube
assembly and position in slotted end of
threaded stud (5). Tighten threaded stud (5)
into threaded holes (2) located in upper end bell
(1). (Tighten both studs.)

Commercial Disposer Leg Assembly (# 11757C)

Commercial

Products Group

1

2

3

5. Loosen outer tube assembly (6).

6. Place o-ring (7) on tube assembly and push up
flush against bottom cover (3).

7. Place washer (8) inside of plug (9) and place on
bottom of tube assembly (6).

8. Install disposer.

9. Adjust legs by turning tube assembly (6) till
assembly legs stand on floor.

5

4

6

7

8
9

Disposer Leg Installation

FigD

PART NO. 13992 (REV. 03/ 13/98)